JETWAY P4XFCU User Manual

Also see for P4XFCP: User manual

Contents

JETWAY P4XFCU User Manual Manual pdf 12 page image

Generally, installing SDR/DDR SDRAM modules to your motherboard is very easy, you canrefer to figure 2-4 to see what a 168-pin SDR/184-pin DDR SDRAM module looks like.DDR2 (BANK2+BANK3)DDR1 (BANK0+BANK1)SDR1 (BANK0+BANK1)Figure 2-4NOTE! When you install DIMM module fully into the DIMM socket the eject tab shouldbe locked into the DIMM module very firmly and fit into its indention on bothsides.WARNING! For the SDR SDRAM CLOCK is set at 133MHz, use only PC133/DDR266-compliant SDR/DDR Modules. When this motherboard operate at 133Mhz, mostsystem will not even boot if non-compliant modules are used because of the stricttiming issues, if your SDR/DDR Modules are not PC133/DDR266-compliant, setthe SDRAM clock to 100MHz to ensure system stability.NOTE! It is only can install either SDRAM or DDR Module at one time. Don’t installboth DDR Module and SDR Module at same time, it will have risk to damageyour Memory and Motherboard.2-5 Expansion CardsWARNING! Turn off your power when adding or removing expansion cards or othersystem components. Failure to do so may cause severe damage to bothyour motherboard and expansion cards.2-5-1 Procedure For Expansion Card Installation1. Read the documentation for your expansion card and make any necessary hardware orsoftware setting for your expansion card such as jumpers.2. Remove your computer’s cover and the bracket plate on the slot you intend to use.3. Align the card’s connectors and press firmly.4. Secure the card on the slot with the screen you remove above.5. Replace the computer system’s cover.6. Set up the BIOS if necessary.7. Install the necessary software driver for your expansion card.10