413-8 Power Management SetupThe Power Management Setup allows you to configure your system to most effectively saveenergy saving while operating in a manner consistent with your own style of computer use.Phoenix – AwardBIOS CMOS Setup UtilityPower Management SetupItem HelpACPI Function EnabledACPI Suspend Type S1(POS)Power Management Option User DefineHDD Power Down DisabledSuspend Mode DisabledVideo Off Option Suspend -> offVideo off Method V/H SYNC+BlankMODEM Use IRQ 3Power Button Function Instant-OffPWRON After Power Failure Always-OffCPU Thermal Management Timer 32 Min> IRQ/Event Activity Detect Press EnterMenu Level >↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General HelpF5:Previous Values F6:Optimized Defaults F7:Standard DefaultsACPI FunctionThis item allows you to Enabled/Disabled the Advanced Configuration and Power Management(ACPI). The settings are Enabled and Disabled.Video Off OptionThis determines the manner in which the monitor is blanked. The choice are Suspend ( off, AllModes ( Off, and Always On.Video Off MethodThis determines the manner in which the monitor is blanked.DPMS (default) Initial display power management signaling.Blank Screen This option only writes blanks to the video buffer.V/H SYNC+Blank This selection will cause the system to turn off the vertical andhorizontal synchronization ports and write blanks to the video buffer.Modem Use IRQThis determines the IRQ in which the MODEM can use.The settings are: 3, 4, 5, 7, 9, 10, 11, NA.Power Button FunctionPressing the power button for more than 4 seconds forces the system to enter the Soft-Off state.The settings are: Delay 4 Sec, Instant-Off.IRQ/Event Activity DetectPlease refer to section 3-8-1