14 englishJabra GO 6430 User manUalJabRa link 350 uSb4.4 Bluetooth® adaPteR SetuP and connectionto connect the Jabra lInK 350 Usb Bluetooth® adapter and set it up for use with your computer and headset:1. plug the Usb Bluetooth® adapter into the free Usb port on your pC.the Usb Bluetooth® adapter installs automatically when you plug it in.Note: even though the basic installation is automatic, you need to have installed the Jabra pC suite softwarebefore the adapter can be used with any softphones (each type needs a specific driver). the Jabra pC suitesoftware is also required for downloading new firmware to the adapter.2. after a few seconds, an led on the Usb Bluetooth® adapter will indicate the current status of the unit. do oneof the following, depending on the status indicated by the led:- Constant green light:the headset and Usb Bluetooth® adapter are already paired and connected and the pC’s softphone is thecurrent target. Go to step 3.- Constant yellow light:the headset and Usb Bluetooth® adapter are already paired and connected and the pC’s softphone is notthe current target. Go to step 3.- Slow-flashing green light:the headset and Usb Bluetooth® adapter are paired but not (yet) connected. make sure your headset isswitched on and close by and then tap the button on the adapter. When the light changes to constantgreen or yellow (see above), your headset is connected.- Constant blue light:the headset and Usb Bluetooth® adapter are not yet paired. the adapter is in pairing mode. this meansthat you need to pair the headset to the Usb Bluetooth® adapter before you connect them. see thesection 9.3: Pairing the Jabra lINK 350 uSB Bluetooth® Adapter and headset for instructions.3. you are now ready to use your headset with your computer. If you have not already done so, then install theJabra pC suite software as described in Chapter 5: Installing and Running the Jabra PC Suite; see also the pCsuite online help.Figure 7: Jabra Go headset paired with both a mobile phone and the Jabra lINK 350 uSB bluetooth® Adapter