RELEASE YOUR JABR A7FRESPTDEITNLSUNOSEDKGRGB 1. Charge your headsetMake sure that your Jabra BT320s is fully charged for 2 hours before you startusing it. Only use the charger provided in the box – do not use chargers fromany other devices as this might damage your Jabra BT320s.Connect the adapter as shown in fig. 2 to the AC power supply to chargefrom a power socket.When the light indicator (LEd) is solid red, your music adapter is charging.When the light turns green, the headset is fully charged.2. Turn on your Jabra BT320s• Press the Answer/End button until you see a long green flash to turnyour headset on. if your headset is not paired with a device (see section3), the headset will flash green every 5 seconds. if your headset isconnected to a device, the headset will flash blue every 5 seconds.• Press and hold the Answer/End button until you see a long red flash toturn the device off.3. Pairing with a phone or other deviceBefore you use your Jabra BT320s you must pair it with a mobile phone oranother Bluetooth enabled device.1. Put the headset into pairing mode:• Make sure headset is turned off.• Press and hold the Answer/End button until the light indicator (LEd) issolid blue.2. Set your mobile phone or other device to ‘discover’ the Jabra BT320sFollow your phones instruction guide. This usually involves going to a‘setup’, ‘connect’ or ‘Bluetooth’ menu on your phone and selecting theoption to discover or add a Bluetooth device. (See example from typicalmobile phone in fig. 4).3. Your phone will find the Jabra BT320sYour phone will ask if you want to pair with it, accept this with “Yes” or“ok” and confirm with the passkey or PIN = 0000 (4 zero’s).Your phone will confirm when pairing is complete. in case of unsuccessfulpairing repeat steps 1 to 3.