Jabra FreeSpeak 250 User Manual

Also see for FreeSpeak 250: User manual

Contents

133. Set your Bluetooth phone to “discover”the headset by following your phone’sinstruction guide. Typically, the stepsinvolve going to a “setup”,“connect”, or“Bluetooth” menu on your phone andthen selecting the option to “discover”a Bluetooth device*.4. Your phone will find the “JABRA 250”headset and ask if you want to pair withit. Confirm this by pressing “yes” or “ok”.5. Enter passkey or PIN = 0000 (4 zeros), then press “yes” or “ok”.Tips for Nokia Bluetooth phones12(Such as Nokia 6310 and 8910 series)Please ensure that the headset is allowed by the phone to connect withoutauthorization. To do this, you must adjust your phone’s settings.Set the following menu options:• Menu > Bluetooth > View Paired Devices > select your headset, press “Options”> Request conn. authorization? — No10 11Enhanced features (for Bluetooth phoneswith hands-free profiles)Enhanced features are available for phones that support the hands-free Bluetoothprofile such as Nokia 3600, 3650, 6310, 6310i, 8910, 8910i, Siemens S55 andS56. Check your phone’s instruction guide or contact the phone manufacturer ifyou are not sure if your phone supports the hands-free Bluetooth profile.You can enable these enhanced features by using the following alternativepairing sequence.* Phone-specific pairing instructions and the most current list of phones withhands-free profile can be found online at www.jabra.com/fscsFig. 6IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidlybefore going back to flashing every 3 seconds. If unsuccessful, the light remains solid,and you’ll need to reattempt pairing (see steps 3–5 above).Once you’re done pairing, the following new headset features will be available:• Last number redial (when not on a call)While the headset is on, press and hold until you hear 2 short beeps,release immediately.• Rejecting an incoming call (when not on a call)When your phone rings, press and hold until you hear 2 short beeps,release immediately.• Call-waiting (swapping between 2 calls)When your phone notifies you of another incoming call while you’re on a call,press and hold until you hear 2 short beeps, release immediately.• Putting a call on holdWhile you’re on a call, press and hold until you hear 2 short beeps, releaseimmediately. Repeat to retrieve the call.4. Leave the headset in the charging cradle for about 3 seconds, then remove theheadset (see Fig. 1).5. Unplug the AC adaptor from the charging cradle.“Pairing” to a Bluetooth phone with hands-free profile:1. Ensure headset is off (see Turningheadset on/off section).2. Press and hold plus the volume upbutton until you see a solid blue light(approximately 8 seconds), then release(see Fig. 5).Fig. 5EnglishEnglish