Jabra GN 9120 Reference Manual

Also see for GN9120 Flex: Quick start guide User manual User guide Quick setup guide Quick setup guide

Contents

Jabra GN 9120 Reference Manual Manual pdf 5 page image

43. Remote handset lifting functionalityAnswering and making telephone calls with GN 1000 RHLYou may purchase a GN 1000 RHL as an accessory, which lets youanswer and end telephone calls while away from your desk. Pleasecontact your vendor or visit www.gnnetcom.com for further informa-tion.To answer a call using the GN 1000 RHL or electronic hookswitch functionality:1. Remove the headset from the base unit when you receive a call.The link will be established and the on-line indicator on the front of the base unit will begin to flash.Note: If you are already wearing the headset, simply press the multifunction button on the headsetmomentarily to answer the incoming call.To end the call, press the multifunction button momentarily or place the headset in the base unit.Making telephone calls using the GN 1000 RHL or electronic hook switch functionality:To make a telephone call using the GN 1000 RHL:1. Remove the headset from the base unit. The link will be established and the on-line indicator on thefront of the base unit will begin to flash.2. Dial the desired number.To end the call, press the multifunction button momentarily or place the headset in the base unit.Note: The connection cord must be connected to your telephone’s handset port (not the headset port)in order for the GN 1000 RHL to function.GN 9120 with Electronic Hook Switch (EHS)The GN 9120 comes in a special version which enables you to answer and end calls while away from yourdesk – without using the GN 1000 RHL. This is, however, only possible on certain telephone systems.In order to determine which telephones have the EHS feature enabled, please refer to our websitewww.gnnetcom.com/gn9120/support/. Please also refer to your telephone’s user manual for clarifica-tion.3 modes are available:• The RHL interface (non-EHS; works with the GN 1000 RHL)• The DHSG interface (for example, with Siemens and Elmeg desk telephones)• The AEI interface (for example, with Tenovis desk telephones)Note: By default, the EHS-version of the GN 9120 is set to the DHSG interface.To toggle between DHSG, AEI and RHL interface, complete the following:1. Place the headset in the base with its on-line indi-cator facing you.2. Press the volume + and volume – buttons on theheadset simultaneously for 6 seconds while theheadset is in the base, until the headset’s on-lineindicator flashes rapidly.3. You are now in interface switching mode, and canset the GN 9120 to work with your telephone’sinterface.4. Using the volume + button to move right and thevolume – button to move left, select the requiredEHS interface.RHL DSHG AEILink iconMute iconCharge iconVolume button– +