In the unlikely event that the Bluetooth Hub is not OK, its LED will flash red.• First, try disconnecting and reconnecting the Bluetooth Hub from the power source.• If the LED is still flashing red, you must reset your Bluetooth Hub.o Press and hold the Bluetooth Hub reset button .o The reset light will turn solid red for 3 seconds, and then turn green.o If the LED is still flashing red, after disconnect and reset, please contact your dealer.IMPORTANT: Following reset, you must pair your Bluetooth Hub and headset.How to pair your Jabra Bluetooth Hub and headsetIMPORTANT: Your Bluetooth Hub and headset have been pre-paired at the factory, sothis step is only necessary if pairing has been lost, e.g. by resetting.• Set your headset into pairing mode by pressing its pairing button . The LED willshow a steady blue light.• Set your Bluetooth Hub in pairing mode by pressing and holding its pairing button .The LED will show a steady blue light, and the two devices will ‘search’ for eachother.NOTE: Both devices will continue to search for a pair for 5 minutes.• When your headset and Bluetooth Hub have paired successfully, the Bluetooth HubLED will flash blue 10 times and then turn green and the headset LED will flashblue slowly.NOTE 1: If you accidentally put either the Bluetooth Hub or headset into pairing mode, tapthe pairing button/ to exit pairing mode.NOTE 2: To be able to use Voice Dial from your mobile phone, please note that you needto pair the Jabra JX10 headset with the Bluetooth Hub before you pair the headset to yourmobile phone.One Bluetooth Hub can be paired with multiple headsets, just as one headset can bepaired with multiple Bluetooth Hubs. Your headset will ‘prioritize’ the Bluetooth Hub ithas been paired with most recently.• If the Bluetooth Hub is paired with multiple headsets, and more than one headsetis in range, the Bluetooth Hub will seek to establish communication with the mostrecently connected headset.11 English