Jabra SP100 User Manual

Also see for SP100: User manual Quick start guide User manual

Contents

Jabra SP100 User Manual Manual pdf 4 page image

4 5EnglishEnglishIn time, rechargeable batteries gradually lose the ability to deliver their full power. Tomaintain the performance of your JABRA SP100 it is advisable to periodically fit a newpair of rechargeable batteries. Follow these instructions for fitting either a new set ofrechargeable 1.2-volt (AA) batteries or a pair of non-rechargeable 1.5 volt (AA) Alkalinebatteries. If you choose to use non-rechargeable batteries DO NOT use the ACadapter or the vehicle power charger with the JABRA SP100.1. Remove the back cover from the speakerphone using a screwdriver and insert bothrechargeable batteries (or non-rechargeable Alkaline batteries) into their individualbattery compartments as indicated. Re-attach the back cover to the speakerphone.(See Fig. 2)2. Rechargeable batteries must be fully charged before the speakerphone is used.Replacing the batteries3“Pair” 2 (Connect) with your Bluetooth mobile phone44. Your phone should find the “JABRA SP100” speakerphone and ask if you want topair with it. Confirm by pressing “yes” or “ok”.5 Enter passkey or PIN3 = 0000 (4 zeros), then press “yes” or “ok”IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidlybefore going back to flashing blue every 3 seconds. If unsuccessful, the light remainssolid, and you’ll need to re-attempt pairing. (See steps 3–5 above)* Phone-specific pairing instructions can be found online at www.jabra.com/fscs1. Turn the JABRA SP100 on.2. Press and hold and the mute button until you see a solid blue light(approximately 5 seconds), then release.3. Set your Bluetooth phone to “discover” the speakerphone by following yourphone’s instruction guide. Typically, the steps involve going to a “setup”,“connect”,or “Bluetooth” menu on your phone and then selecting the option to “discover” aBluetooth device*. (See example from a Sony Ericsson T610 in Fig. 3)USING YOUR JABRA SP100Before using your JABRA SP100, ensure that the batteries are charged and the JABRASP100 is paired with your Bluetooth mobile phone and switched on.Using your mobile phone’s keypad1. Dial number on keypad.2. Press phone’s “send” key.Using voice-dialing (if supported by your phone)1. Press and release once. You’ll hear 1 short beep while doing this.2. You’ll then hear the voice-activation tone; say the name of the person you wish to call.NOTE: Record voice tag via your mobile phone.Making a call5• Press and release onceOR• End call from your mobile phone’s keypadEnding a call6Answering a call7• After you hear the ring tone, press and release onceOR• Answer the call with your mobile phone’s keypad. You may then need to transfer thecall to the speakerphone by pressing and releasing once (depending onyour phone)Fig. 3Fig. 2SP100 User Guide_NA.qxd 5/7/04 2:46 pm Page 4