Jackson Grills JLS400-LP Assembly, Use And Care Manual

Contents

Jackson Grills JLS400-LP Assembly, Use And Care Manual Manual pdf 9 page image

9 Flame Diffusers, Cooking Grids Installation:1. Remove the flame diffusers form the packaging. Please ensure that all protective plastic has beenremoved from these parts. These flame diffusers should be placed on the ledge installed on thefirebox front and rear. Ensure that all of the flame diffusers have been installed correctly in the slotsprovided or the unit will not work correctly.2. Once the flame diffusers have been installed, the cooking grids can be installed into the grill. Placethe cooking grills on the upper ledge of the firebox.3. Remove warming rack from packaging and install above cooking grids on the 2 brackets on theinner hood. Rear Burner Igniter:1. Unscrew the plastic/rubber cap from the rear burner ignition module and insert the supplied AAAbattery, positive side facing out. Re-install cap. LED Light:1. Open the folding access panel on the underside of LED light base and install 3 supplied AAAbatteries.Gas ConnectionONLY USE THE REGULATOR AND HOSE ASSEMBLY PROVIDED WITH THIS GRILL.REPLACEMENT PRESSURE REGULATORS AND HOSE ASSEMBLIES MUST BETHOSE SPECIFIED BY THE MANUFACTURER.This is a L.P. (Liquefied Petroleum Gas) configured grill. Do not attempt to use a natural gas supplyunless the grill has been reconfigured for natural gas use.The installation of this appliance must conform with local codes or, in the absence of local codes, withthe National Fuel Gas Code, ANSI Z223. 1, or CAN/CGA-B149.2 Propane Installation Code. L.P. tank Requirements:The L.P. tank used with your grill must meet the following requirements:1. Measurement: 12’’(30.5cm) (Diameter) X 18’’ (45.7cm) (Tall)2. Maximum Capacity: 20lbs. (9Kg)3. Constructed and marked in accordance with the specification for L.P.-gas cylinders of the U.S.Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339,Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods. See L.P. tank collarfor marking.4. Be arranged for vapor withdrawal.5. Has a collar to protect the tank valve.6. No dents or rust. A dented or rusty L.P. tank may be hazardous. L.P. tank valve used must meet the following requirements:1. Have type I outlet compatible with regulator provided.2. Have safety relief valve.3. UL listed Overfill Protection Device (OPD), This OPD safety feature is identified by a uniquetriangular hand wheel. Only use tanks equipped with this type of valve. (as the figure shownbelow)