Jackson Grills LS700BI-LP Owner's Manual

Also see for JLS700BI-NG: Owner's manual

Contents

Jackson Grills LS700BI-LP Owner's Manual Manual pdf 7 page image

7Tools Required for Assembly:Please use the proper tools to simplify installation and prevent injury or damage to your grill. Installer Supplied Tools:1 x Large Phillips Screwdriver1 x Medium Phillips Screwdriver1 x OPTIONAL: Socket wrench with 6mmSocket and extensionAssembling & Preparing your Grill: CHECK BURNER FIT on ORIFICES:1. Inspect burners to ensure that they are all inserted correctly ontothe orifices (AKA the outlet of the valves; Fig 1)2. If any burner is NOT correctly installed over the valve as shown in Fig 1,remove the burner retaining clip, remove the burner, and reinstall correctly. INSTALL FLAME DIFFUSERS & COOK GRIDS:1. Remove the flame diffusers, grids & warming rack from the packaging.2. Install each diffuser directly above each burner by setting them into theslotted ledges, in the front and rear of the firebox. (Fig. 2)3. Once the flame diffusers have been installed, set the cooking grids on theupper ledges of the firebox in the grill, with the grill bars oriented front to rear.4. Install the warming rack above cook grids, on the 2 brackets located onthe left & right inner walls of the inner hood. PREPARE REAR BURNER IGNITER:1. Unscrew the plastic/rubber cap from the rear burner ignition module, and insertAAA battery (supplied) with the positive end facing out. (Fig. 3)2. Re-install cap. INSTALL ROTISSERIE KIT: (For Rotisserie Cooking)1. Carefully remove the rotisserie kit parts from the packaging.2. Install the motor mounting bracket supplied to the left hand side of the inner hood. (Fig. 4)3. Install the motor on the motor bracket.Figure 1Figure 2Figure 3Tip of brass orifice, onend of valve; correctlyhidden inside burner.Main burner