Jackson Systems Wireless Comfort WCT-32 Installation Manual

Also see for Wireless Comfort WCT-32: User manual User manual Installation manual

Contents

Jackson Systems Wireless Comfort WCT-32 Installation Manual Manual pdf 3 page image

3Hold the sub-base with one hand, press the caseas shown below and pull the bottom of thethermostat from the sub-base.Press here to releasecase from sub-base.Removing the Sub-Base4ThermostatThe thermostat should be located in an area thatrepresents the ambient space temperature andwithin 100 feet of the HVAC Control Module. Donot install the thermostat in an area where draftsare present, near the floor, behind doors or on anexternal wall. Avoid placing the thermsotat inareas where the air movement is limited, affectedby direct sunlight or other areas not typical of thetemperature in the space.Location3 The thermostat should be installed approximately5 feet above the floor.Level the sub-base for appearance and use thewall anchors and screws provided.Installing the Sub-Base5Slide the battery cover off and install two AAbatteries included with the thermostat. Install thebatteries with the positive terminals to the right asshown. Replace the battery cover.Installing the Batteries6The LCD will display the time of day, the setpointtemperature and the room temperature.4