Jacuzzi DESIGNER BATH SERIES Installation & Operation Instructions

Also see for CIPREA: Installation & operation instructions Instructions for preinstallation

Jacuzzi DESIGNER BATH SERIES Installation & Operation Instructions Manual pdf 25 page image

ENGLISH25Jacuzzi Whirlpool Bath K339000X 3/06General Whirlpool Bath Troubleshooting GuidePROBABLE CAUSESPROBLEM REMEDYPump/Motor does not start.Pump/Motor operates but no fullyadjustable jets are functioning.Pump/Motor operates but air is notinjected into water.Water leakage from pump unions.Pump/motor shuts off by itself beforeset time elapses.Control panel not responding.Lighting does not workNo power to pump/motor.Pump/motor not plugged in.Pump/motor faulty.Jets are closed.Control panel cable disconnected.Suction cover may be clogged.Air valves closed.Overtightened, O-ring may bepinched or improperly seated, undertightened.Motor thermal protection has deacti-vated pump/motor due to overheat-ing. (Supply voltage low.)GFCI tripped.Inadequate supply wiring.No power to control panel.Cable disconnected or broken.Reset GFCI.Insert plug fully into outlet.Replace pump/motor assembly.Open jets by rotating counterclockwise.Reconnect control panel cable at controlor junction box.With motor turned off, remove safetycover and remove any debris. Cleanthoroughly before replacing. Replacesuction cover before operating.Use electronic controls to open airvalves. Reset air valves to allow air flow.Untighten unions check and reseat O-ring. If O-ring has been pinched out ofshape, replace (refer to number below).When tightening union nuts, handtighten only.Let motor cool; thermal protection willreset. Check for proper ventilation.(Check supply voltage.)Reset GFCI. If it continues to trip do notuse this unit. Disconnect the unit andhave the problem corrected by alicensed electrician before using.Consult a licensed electrician to correctwiring to unit.Power down the system by either unplug-ging the unit or shutting off the power atthe house breaker panel. Wait 15 sec-onds then power back up. Retry the sys-tem by activating the feature that was notresponding.Reconnect loose cable. Repair brokencable wires.NOTE: If unit is within the warranty period, contact Jacuzzi Whirlpool Bath Service Support at 1 - (800) 288-4002 with bath's serialnumber before work is started. The Serial Number is located on the Specification/Serial Number Plate. See page 26.

/ 28

Related manuals for Jacuzzi CIPREA