Jacuzzi J-460 Owner's Manual

Also see for J - 465: Instructions for preinstallation Instructions for preinstallation Owner's manual Owner's manual Owner's manual

Contents

Jacuzzi J-460 Owner's Manual Manual pdf 39 page image

Page 35J-400 Series11.0 Programming Instructions11.1 Programming Filter/Circulation Pump Run TimeThe Sentry control system allows you to easily adjust two separate aspects offilter/circulation pump operation:1. The time of day (start time) the filter/circulation pump turns on.2. The length of time (duration) the filter/circulation pump operates.The factory default start time is 12:00AM (Midnight). The default duration is 24hours. To make adjustments, press the CYCLE button to enter the filter/circulation pump programming mode. “Circ” appears on the LCD. Now, thesystem is ready to accept your changes:• Press the SELECT button once. The previously programmedstart time appears on the LCD display.• Press WARMER or COOLER buttons to adjust the starttime in 30-minute increments.• Press the SELECT buttons to program duration.• Press WARMER or COOLER buttons to program theduration time in 1 hour increments.• Press DISPLAY button to save changes and recall the main watertemperature display. Note: If no button is pressed within 30 seconds, allchanges are recorded and the screen automatically returns to the standardwater temperature display.Note: When the standard mode is selected (sec. 10.3, page 34), the filter/circu-lation pump automatically turns on for a heat call regardless of the pump’sprogrammed start time and duration.11.2 Programming Filter CyclesYour spa comes with four 30-minute filter cycles which activate the filter/circu-lation pump. These cycles are factory programmed to start at 6:00 am, 12:00p.m., 6:00 p.m., and 12:00 a.m. The control system allows you to easily adjusttwo separate aspects of each cycle: 1) the time of day at which it begins; 2) theduration of the cycle.Note: When “Standard” mode is selected (sec. 10.3, page 34) and the filter/circu-lation pump is set to the factory default duration of 24 hours (sec. 11.1), noapparent change of operation will occur. However, when “Economy” mode isselected (sec. 10.3, page 34), the heater activates only during a programmed filtercycle.