Jacuzzi J-DREAM II Owner's Manual

Also see for J-DREAM II: Owner's manual Manual

Contents

Jacuzzi J-DREAM II Owner's Manual Manual pdf 9 page image

7Rough-inWASHINGMACHINEOUTLETBOXCONNECT #8 GAUGE (10mm2)MINIMUM SOLID COPPER BONDWIRE TO THE HOUSEELECTRICAL PANEL ORAPPROVED LOCAL GROUND.AN APPROVED GROUND MAYBE AN 8 FOOT LONG GROUNDROD (3 METER LONG EARTHROD), A PLATE ELECTRODE, OROTHER ACCEPTABLE BOND.CHECK YOUR LOCAL BUILDINGCODE FOR REQUIREMENTS.(SEE PAGE 23 FOR BONDINGINSTRUCTIONS).ELECTRICALOUTLET 240V15A RATING TOBE ON A GFCIPROTECTEDCIRCUITHOSEBIBB (2)(2) 1/2 " HOT& COLDWATERSUPPLYLINES16"FINISHEDWALLS2 " WASTE STUBOUT21-1/2"11-5/8"FINISHED WALLSURFACEFINISHED FLOORMATERIAL60"FINISHEDMINIMUMIMPORTANT: This is the installed position ofthe waste stub-out when connected to theshower drain. If the stub-out is installed beforethe shower unit, leave enough flex in the wasteline to allow the end of the stub-out to beblocked temporarily (see page 10) in a positionunder flush to the floor surface. This will allowthe shower unit to slide across the floor intoposition without having to lift it.IMPORTANT: The shower drain is designedto connect to a 2 inch (50mm) ABS or PVC (asapproved by local codes/standards) wastestubout.End of 2 inch (50 mm) waste stubout must belocated to these dimensions within 1/4 inch(6mm).40 "55 "FINISHED WALLSURFACE* Stub-out for steam tank draindown line should be minimum1/2" copper tubing. Provide3/4" male pipe thread fitting onend of copper drain line.42"3"3"13"* This drain line must beprovided for the steam tankdrain to site drain as requiredby local codes/standards.J-Dream II Owner's Manual