Jacuzzi J-LXL Installation Manual And Use & Maintenance

Also see for J - LXL: Instructions for preinstallation Instructions for preinstallation Instructions for preinstallation Owner's manual Owner's manual

Contents

Jacuzzi J-LXL Installation Manual And Use & Maintenance Manual pdf 41 page image

Note: If the spa power is interrupted, the duration count- timer isnot affected. The number of days remaining is stored in the mem-ory and will continue to count- once power is regained.If the duration count- timer is not at “0” and you need to reset it:A. Press and hold the Jets pump 1 and Cooler buttons at thesame time for 3 seconds.B. Press the Warmer button to scroll to “U”.C. Press the Jets pump 1 button to switch from “U” to “O3”.C. Press and hold the Jets pump 1 and Cooler buttons at thesame time for 3 seconds.E. Press the Warmer button to scroll to “O3”.D. Press the Jets pump 1 button to switch from “O3” to “U”. Thetimer has been reset to 365 days.Spa maintenanceProper and regular maintenance of your spa will help it retain itsbeauty and performance.Information regarding spa cleaning and maintenance andthe products to be used can be found in the catalogue-guideprovided with the product. Cleaning the filtersYour Jacuzzi ® Premium spa is equipped with a skimmer and twohigh-performance filter cartridges located inside the skimmer.Fine debris is filtered by the circulation pump drawing waterthrough the skimmer bag and circulation pump cartridge.The largest impurities are filtered by the two-speed pump thatforces the water into the skimmer net and the other filter car-tridge during normal hydromassage operation (high speed) andevery filtering/heating cycle (low speed).Clean the filter cartridges once a month, increasing the frequencyduring periods of intense usage.ALWAYS TURN POWER TO SPA BEFORE CLEANING THE FILTERCARTRIDGES!Refer to the filter cleaning/replacement procedure below:A. Turn off power to spa.B. Tilt cover forward to access filter cartridges.(The skim shield is connected by spring clips, use caution so thelid does not snap back.)C. Remove the skimmer netand cap from the catches and cleanthem; then refit the net in the cap.Replace the cap approximately every three months, dependingon how much the hot tub is used.D Rotate each filter cartridge handle counterclockwise to un-thread from mating wall fitting.E. Lift unthreaded filter cartridge from skimmer well.F. Rinse the filter folds on each cartridge. Start from the top andwork down in the direction of the handle.Repeat until all the folds have been cleaned.Start at the top and work -ward towards handle. Repeat until allpleats are clean.G. Submerge both filter cartridges in spa. Tilt threaded end up-ward to remove trapped air bubbles, then keep cartridges sub-merged to prevent air entrapment during installation (step H).B C D(Spa Shell)E F GTrappedAirBubblesCartridge 1Cartridge 2H I J41