NEO-ANGLESINGLE THRESHOLDPRODUCT CHARTJ-STONE ™SHOWER BASESWHIRLPOOL BATHRBACDAADDBCBD21-3/16"17-3/16"17-3/16"18-3/16"12-3/16"12-3/16"C21-3/16"24-3/16"30-3/16"18-3/16"25"25-1/8"B42-3/16"34-3/16"34-3/16"36-1/8"18-3/16"20-3/16"A42-3/8"48-3/8"60-3/8"36-5/16"36-1/8"38-1/8"MODELSS 4242SS 3448SS 3460SS 3636SS 36NEOSS 38NEOROUGH-IN DIMENSIONPRODUCTNO.PO45PO41PO46PO42PO43PO44NOMINALSIZE42" X 42"34" X 48"34" X 60"36" X 36"36" X 36"38" X 38"INSTALLATIONWith the drain fitting passing over the center of thedrainpipe, lower the shower base carefully into place,push down firmly until the base is in place.Provide an opening in the subfloor no less than 5" x 5"square. See product chart for hole location. Theopening is to accommodate a 2" waste pipe.If the subfloor is level, no other preparation is neces-sary. You can proceed to install the shower base. If thesubfloor is not level, you MUST level the entire surfaceprior to installing the base. (Use a floor leveling com-pound.) Do not level shower base with mortar. Bothsides of a joint or splice of subfloor should be level toeach other. Level and support waste pipe cutout areagreater than 5" x 5".