Jacuzzi LG72000 Installation Manual & Warranty Information

Contents

Jacuzzi LG72000 Installation Manual & Warranty Information Manual pdf 7 page image

Installation Englishwww.jacuzzi.com Page 7Assemble in accordance with the local plumbing orbuilding codes.1. Identify drain overflow kit provided with your bathtub.Remove and open the overflow package and confirmthat all parts are present.2. Remove washers and nuts from the overflow fitting.3. Place a small bead of plumbers putty, silicone, orsimilar approved sealant around the underside of thetop flange of the overflow fitting.4. Place the overflow fitting into the overflow hole of thebathtub (Figure 4).5. From the underside of the unit, place the rubber washerthen locknut on the overflow fitting and tighten securely.Be careful not to overtighten.6. Assemble the remaining drain pieces as shown in theillustration.7. After the drain is fully installed, test for proper drainage.If the unit does not drain properly, rectify this conditionbefore proceeding with further bathtub installation.Watertight installation of the drain and overflowis the installer’s responsibility. Drain leakage isexcluded from the Jacuzzi Luxury Bath warranty ofthis product.OPTIONAL - If the Fuzion® Wood Frame is notbeing used, please proceed to Step 2 in theUndermount Installation section on page 11.Fig. 4Overflow FittingApply sealant/caulking(commercially available)Flat RubberWasherLock NutDirect Waste Overflow DrainFuzion® Specific MaterialFuzion® Overflow Drain InstallationFigure 4 - Overflow InstallationThe additional design features of the Fuzion® require that the following steps be completed prior to installing the bathtubin the constructed surround. The following steps must also be completed in the order specified:1. Fuzion® Faucet Installation2. Fuzion® Overflow/Drain Installation3. Fuzion® Wood Frame Installation4. Fuzion® Control Panel InstallationFuzion® Faucet InstallationSelecting a faucet for rim mounting: The combined thickness at the rim of the bathtub shell and optionalwood deck is 2˝ (50mm) nominal. The length of the faucet tailpiece(s) must be long enough to extend pastthis dimension and have ample clearance to assemble any hardware (i.e. locknut, water supply fittings, etc.)necessary for installation. For undermount units, the combined thickness of the bathtub shell is ½˝ (12mm)nominal and the undermount deck should not exceed the length of the faucet tailpiece(s), including anyassembly hardware.Overflow DrainAssemblyDirect WasteOverflow DrainWaste ElbowTwist and TurnDrain AssemblyPVC PipePVC PipePVC Flex PipePVC Flex PipePVC Flex PipePVC 45 ElbowPVC 45Elbow StreetPVC 45 Elbow StreetPVC 45 Elbow