Page 4 www.jacuzzi.comInstallationEnglishImportant Safety Instructions (cont.)WARNING! RISK OF SEVERE INJURY! To avoid injury, use care when entering and exiting the hydromassagebathtubCAUTION! Do not use drugs or alcohol before or during the use of a hydromassage bathtub equipped with a heater.People using medications or having an adverse medical history should consult a physician before using a hydromassagebathtub equipped with a heater. Possible drowning may occur.WARNING! RISK OF SEVERE INJURY OR DEATH! Do not use a hydromassage bathtub equipped with a heaterimmediately following strenuous exercise.CAUTION! TO DECREASE RISK OF PRODUCT DAMAGE. Use this unit only for its intended use as described inthis manual. Do not use attachments not recommended by the manufacturers. Do not tamper with user-operated controlsor such devices.SAVE THESE INSTRUCTIONS.Jacuzzi Luxury Bath (the “Company”) has obtained applicable code (standards) listings generally available on a nationalbasis for products of this type. It is the responsibility of the installer/owner to determine specific local code complianceprior to installation of the product. The Company makes no representation or warranty regarding, and will not be respon-sible for any code compliance. Product specifications are subject to change without notice.Visual Inspection1. Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed staples.Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the product has beenmade. Do not lift the bathtub by the plumbing at any time; handle by the shell only.2. Inspect the shell and bathtub components. Should inspection reveal any damage or defect in the finish or visibledamage to any components, do not install the bathtub. Damage or defect to the finish claimed after the bathtub isinstalled is excluded from the warranty. The responsibility of Jacuzzi Luxury Bath for shipping damage ceases upondelivery of the products in good order to the carrier.3. Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the publishedwarranty information packed with the product or in the back of this manual.Bathtub Water and Operational TestAll bathtub units are factory tested for proper operation and watertight connections prior to shipping. However, the unitmust be retested by the installer prior to installation. Jacuzzi Luxury Bath is not responsible for any defect that could havebeen discovered, repaired, or avoided by following this inspection and testing procedure:1. Place the bathtub on a level surface, near appropriate electrical supply, water supply, and water drainage. A drivewayis a suitable choice.2. Cover the drain and overflow hole with tape or a stopper and fill the bathtub to the bottom of the overflow hole.3. Allow bathtub to stand for 5 minutes.4. Plug in motor/pump and turn unit on. Confirm that all features function as described in the Operation section of thismanual. Do not install the bathtub if bathtub fails to operate as described.5. Visually inspect all joints for leaks. Do not install the bathtub if leaks are detected.6. Return bathtub to box or otherwise protect from damage until time of installation.Inspection and Testing