Janam XG100 User Manual
Also see for XG100: Quick start guide
                                                   | |
XG100 User Manual2-4Janam Technologies LLCInstall the BatteryIMPORTANT Battery Warning!CAUTION: Use only Janam-approved batteries.There is the risk of explosion if battery is replaced by an incorrect type.Always dispose of used batteries according to the instructions.INSTALLING THE BATTERY:1. Insert the top of battery into chamber opening and gently slide battery into battery chamber.Do not force past point of resistance.2. Turn the battery so that the base of the battery is perpendicular to the device handle.This aligns the battery notches with the battery chamber which is required to insert the battery. Once thebattery is properly aligned with the handle, press the battery into the battery chamber.3. Turn the battery base clockwise until the base of the battery is parallel with the device. The battery releaseplunger will click and lock the battery into place.REMOVING THE BATTERY:1. To remove the battery, fully press the battery release plunger and hold while rotating the battery counter-clockwise until it stops (battery base will be perpendicular to device handle).2. Grip the battery base and pull battery from battery chamber.CHARGING THE BATTERY:Important Note: The main battery charges the backup battery in the XG100. Once the main battery is fullycharged, do not remove it from the unit for 24 hours.To charge the battery using the USB Syncing/Charging Cable or Serial Syncing/Charging Cable:1. Connect the power supply to the USB or serial syncing/charging cable.2. Connect snap-on end of USB or serial synching/charging cable to syncing/charging connector at thebottom of device, making sure the JANAM logo on the connector faces up.3. Insert appropriate AC adapter and plug in the power supply. Use only easily accessible wall outlets thatare easily reached with the length of supplied power cable.To charge the battery using the Single-Slot or Four-Slot Cradle:1. Connect the power supply to the cradle.2. Connect the line cord to the power supply.3. Insert appropriate AC adapter and plug in the power supply. Use only easily accessible wall outlets thatare easily reached with the length of supplied power cable. |
Related manuals for Janam XG100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine