Janome MO200 Service Manual
                                 | |
Contents
| 
14MO2005200QDCMECHANICAL ADJUSTMENTZIGZAG SYNCHRONIZATIONThe needle should start swing 8.2 mm above the surface of the needle plate when the machine is set forzigzag stitching.1. Remove the front cover (refer to page 7).2. Turn on the power switch, select the pattern no. 2 and set the machine at the maximum zigzag width.3. Turn the handwheel toward you slowly with your hand until the needle start to sewing. Loosen thesetscrew and turn the upper shaft shield plate in the direction of;* A. If the swing point is higher than 8.2 mm.* B. If the swing point is lower than 8.2 mm.4. Position the upper shaft shield plate as close as possible to the left.(It should not touch the upper shaft sensor).5. Check the swing point by turning the handwheel, then tighten the setscrew.6. Attach the front cover.Needle #148.2 mmSurface of needle plateBAUpper shaft shield plate SetscrewUpper shaft sensor |
Related manuals for Janome 5200QDC
manualsdatabase
Your AI-powered manual search engine