Jecod DCP-3000 Owner's Manual
   | |
Contents | 
Used as submersible pumpsIMPORTANT: Do not let the pump run dry – this could causedamage to the motor.l Submerse the pumps completely in your pond so as to make the pump body fillwith water.l A water level of approx. 15 cm (6 in.) is required for submersible use in order toprevent the pump from taking in air.l To prevent the filter becoming prematurely clogged, place the fountain pumpabove the mud in the pond!l Install the enclosed filter sponge to prevent the fountain inlet from becomingclogged.l Running in conjunction with fountain jets, the pump should be stationed firmlyand horizontally (on a brick).l The pump can be switched on by simply plugging it in and switched off byplugging off.Used as non-submersible pumpsl Position the pump lower than the water surface on the side of the pond so that thewater can be drained to the pump because it is not self-priming.l Remove the filter cover and connect suction hose (A: inlet) and pressure hose (B:outlet) from the pump. The connection should be waterproof.(see Figure 1)l Fill the suction hose and pump with water before turning it on.l To prevent the pump from becoming clogged, provide the suction hose with anadequate suction filter.l Never let the pump run dry.Installation diagram:Figure 1Figure 2MAINTENANCETo clean the pump, remove the back cover, sealing cover and the impeller.Use a small brush or stream of water to remove any debris.If the pump not work, check as following:l Check the circuit. Please try to plug on another power socket, to ensure the pumpswitched on with power. Note, please do not plug on before operation.l Check the pump outlet and tube, if blocked by dirty. Algae may block them, up ican clean the algae using the pond water with a garden hose.l Check the inlet to ensure not clogged by debris.l Remove the pump inlet to access the impeller. Turn around the rotor to check ifbroken or jammed.l Monthly maintenance will prolong your pump’s life. Clean the rotor, remove thedirt. etcNOTE: Ensure the electrical cord loops below the power socket like a “DripLoop”. It will prevent the water from running around the cable into the powersocketDISPOSAL:Do not dispose this product as unsorted municipal waste. Collectionof such waste separately for special treatment is necessary. Thisproduct must not be disposed together with the domestic waste. Thisproduct has to be disposed at an authorized place for recycling ofelectrical and electronic appliances. By collecting and recycling waste, you helpsave natural resources, and make sure the product is disposed in an environmentalfriendly and healthy way.Jecod Co.,LtdTongmao Industrical Park, Dongsheng Town, Zhongshan, Guangdong. China.Email: info@jecod.com Website: www.jecod.comTel: +86-760-28136717/19/20 Fax: +86-760-28136725OutletScrew NutController AdaptorHolderRubberPump BodyPump Cover RotorO-RingO-RingInlet WATTSDCP-200WPump ControllerAB |
Related manuals for Jecod DCP-10000
manualsdatabase
Your AI-powered manual search engine