Jenn-Air 30" (76.2 CM) Installation Instructions Manual

Also see for JGRP536WP: Design and planning guide Installation instructions

Jenn-Air 30" (76.2 CM) Installation Instructions Manual Manual pdf 11 page image

11Electronic Ignition SystemInstall Burner Bases and Burner CapsInstall the burner base, making sure the igniter electrode isproperly aligned with the base. Place burner caps on top ofburner bases. If burner caps are not properly positioned, surfaceburners will not light.Initial Lighting and Gas Flame AdjustmentsCooktop burners use electronic igniters in place of standingpilots. When the cooktop control knob is turned to any position,the system creates a spark to light the burner. This sparkingcontinues until the flame is lit or the knob is turned to Off.Check Operation of Cooktop BurnersPush in and turn each control knob to the “LITE” position.The surface burners and grill flames should light within4 seconds. The first time a burner is lit, it may take longer than4 seconds to light because of air in the gas line.After verifying the proper burner operation, turn the control knobsto OFF.If burners do not light properly:■ Turn cooktop control knob to the “OFF” position.■ Check that the range is plugged in and the circuit breaker hasnot tripped or the fuse has not blown.■ Check that the gas shutoff valves are set to the “open”position.■ Check that burner caps are properly positioned on burnerbases.Repeat start-up. If a burner does not light at this point, contactyour dealer or authorized service company for assistance.Flame HeightThe cooktop flame should be a steady blue flame approximately¼" (0.64 cm) high.Dual Flame BurnerSingle Flame BurnerTo Adjust Flame Height:1. Unplug range or disconnect power.2. Remove burner grates.3. Remove the control knobs.4. Open the oven door and remove the 2 screws on each side ofthe range that hold the control console in place.NOTE: Make sure to leave oven door open or the controlconsole will not rest in the side brackets properly once it isdetached.5. Pull up on the control console and let it drop forward into thenotched console brackets on each side.6. Remove the round gasket from the valve stem.7. Put a control knob onto the valve stem of the burner you wantto adjust.20,000 Btu/h Ultra Power™ Dual-FlameBurnerA. IncorrectB. Correct15,000 Btu/h Professional BurnerA. IncorrectB. Correct5,000 Btu/h Simmer/Melt BurnerA. IncorrectB. CorrectABABABA. Upper (simmer) flameB. Lower flameA. Control console bracketABA