Jenn-Air 36" Installation Manual

Also see for JB36NXFXLW: Use and care guide Installation guide Energy guide Manual Product dimensions

Contents

Jenn-Air 36" Installation Manual Manual pdf 27 page image

273. Depending on your model and the compartment, rotate theplastic spacer so that the curved handle mounting posts areeither at the top, bottom or to the left. See following chart.4. Slide the screw into the handle mounting stud. Insert thescrew assembly into the center hole of the plastic spacer andfasten it to the door panel.5. Install the handles to the handle mounting studs so that thesetscrews are on the designated side and tighten thesetscrews.Install Base GrilleThere are two pieces to the base grille to allow for a custom fit: thebase grille itself and the skirt. The skirt can be added to the basegrille in order to extend it all the way to the floor.1. To see whether the skirt is needed, place the base grille intoposition. Do not attach the base grille to the refrigerator.Measure the distance between the bottom of the base grilleand the floor. The gap must be a minimum of ¹⁄₂" (1.27 cm) inorder to add the skirt.NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skipsteps 3 and 4 of the instructions, and install the base grilleonly.2. Remove the film from the base grille.3. Snap the skirt onto the base grille.4. Trim the skirt by scoring the proper “V” groove with a utilityknife. Break the skirt at the score line.5. Using the two screws, attach the base grille assembly to therefrigerator as shown.NOTE: Drive in the right side screw first.Complete Installation1. Turn the water supply line valve to the “Open” position.2. Turn the refrigerator switch to the ON position. See “PowerOn/Off Switch” in the Use & Care Guide for instructions. Waita few minutes. Check the water line connections for leaks.3. Remove all boxes, parts packages and packing materials fromthe interior of the refrigerator. See the “Cleaning” section inthe Use & Care Guide for instructions. Remove the film andcardboard from the grille and doors or door frame, dependingon your model.4. Install the shelves and bins in the refrigerator and freezercompartments.5. The controls are preset at the factory to the midpoint setting.Check that the compressor is operating properly and that allthe lights are working.6. Flush the water system before use. See “Water SystemPreparation.”To get the most efficient use from your new built-in refrigerator,read the Use & Care Guide. Keep Installation Instructions and Use& Care Guide near the built-in refrigerator for easy reference.Bottom Mount French DoorBottom MountBothModelsRefrigerator Refrigerator FreezerLeftSwingRightSwingLeftDoorRightDoor DrawerCurvedMountingPostBottom Top Bottom Top LeftSetscrews Right Left Right Left DownA. Base grilleB. SkirtABA. “V” grooveA. Screws (2)AA