Jenn-Air 36inch AND 42inch (91.4 CM AND 106.7 CM) ISLAND CANOPY RANGE HOOD Use & Care Manual

Also see for 36": Use and care guide Installation Instructions and Use & Care Guide Installation Instructions and Use & Care Guide Installation Instructions and Use & Care Guide Installation instructions

Jenn-Air 36inch AND 42inch (91.4 CM AND 106.7 CM) ISLAND CANOPY RANGE HOOD Use & Care Manual Manual pdf 11 page image

116. Install the lower duct cover (rear) to the range hood canopy.Spread the lower duct cover opening slightly and position itover the upper duct cover. Set the lower duct cover in place.Position so the flanges of the lower duct cover set into theflanges of the upper duct cover. Make sure the front and rearlower duct covers mate properly.NOTE: When assembling the rear lower duct cover to the frontlower duct cover, the flange (both sides) must be placed over theplastic clip to secure the lower duct covers together at the bottom.7. Secure the lower duct covers together at the top using 2plastic clips. Use one plastic clip on each side.8. Secure the lower duct cover to the range hood canopy using4 - 4.2 x 8 mm screws.Complete Installation1. For non-vented (recirculating) installations only, installcharcoal filters onto the metal filters. See the “Range HoodCare” section.2. Install metal filters. See the “Range Hood Care” section.3. Check the operation of the range hood blower and light. Seethe “Range Hood Use” section.If range hood does not operate, check to see whether acircuit breaker has tripped or a household fuse has blown.NOTE: To get the most efficient use from your new range hood,read the “Range Hood Use” section.A. Lower duct cover (rear)B. Plastic clipsC. Lower duct coversD. Upper duct coversA. Plastic clips (2)B. Lower duct covers top clip areaABDCAB