Jenn-Air 740-0711 Installation Instructions And Use & Care Manual

Also see for 740-0711: Use & care guide

Contents

Jenn-Air 740-0711 Installation Instructions And Use & Care Manual Manual pdf 12 page image

12INSTALLATION INSTRUCTIONSUnpack GrillExcessive Weight HazardUse two or more people to move and install grill.WARNINGFailure to do so can result in back or other injury.Unpack Grill1. Remove all packaging materials and remove grill from the shippingbase.2. Move grill close to desired outdoor location.3. Open the grill hood.4. Using an utility knife to cut yellow straps and packing tape to openbox from top and remove the boxes.5. Remove the warming shelf and grill grates from inside the grill andremove the package inside the firebox.6. Remove foam block and wrap from inside the grill.7. Replace the grill grates.8. Place warming shelf on brackets as shown.ABAA. Warming shelf bracketsB. Warming shelf9. Dispose of/recycle all packaging material.Install 20 lb LP Gas Fuel Tank TrayThe tank tray should be secured to a fixed location that can be easilyaccessed and will allow the gas pressure regulator/ hose assembly toconnect to the 20 lb LP gas fuel tank without kinking or putting strain onthe gas pressure regulator/ hose assembly.1. Place the tank tray in a location that can be secured using 4 screws (supplied) through the predrilled holes.2. Use 4 screws to secure the tank tray. The typical location for a 20 lbLP gas fuel tank is within the enclosure where the tank ban be turnedon and off easily.AA. Four 5/32" x 10 mm truss head screwsInstall GrillPlace grill into outdoor enclosure, but leave enough room in the back toconnect to the gas supply.LP Gas Installation1. Check that the LP gas pressure regulator/hose assembly ispositioned under the grill (as shown in the following illustration)and is not pinched or kinked.2. Use 4 screws and the 2-piece 90° clamp mounting bracket providedto attach the 90° brass connector to the back of the enclosure. Thebrass connector is located between the flexible gas hose and the LPgas pressure/hose assembly.BAA. 4 screwsB. 2 piece 90° clamp mounting bracket