Jenn-Air JDRP436WP02 Installation Instructions Manual

Also see for JDRP430WP01: Use & care guide

Contents

Jenn-Air JDRP436WP02 Installation Instructions Manual Manual pdf 10 page image

2, Determine and mark centerline of the cutout space. Themounting bracket must be installed on the right side of thecutout. Position mounting bracket in cutout as shown in thefollowing illustration.Measurement B:30" (76.2 cm)ranges: 11%" (29.5 cm)36" (91.4 cm) ranges: 14%" (37.1 cm)48" (121.9 cm) ranges: 20%" (52.4 cm)Measurement C:Optional distance from backwall. If backwall is constructed ofa combustible material and a backguard is not installed, a6" (15.2 cm) minimum clearance is required for all models.Install anti-tip bracket accordingly.IIIliltCA. CenterlineB. Centerline of cutout to centerlineof anti-tip bracketC. Backwall to back of range3. Drill two 1/8"(3.0 mm) holes that correspond to the bracketholes of the determined mounting method. See the following.Floor MountingAl"'i O O\Wall MountingA. #12 x 1%" screwsB. Anti-tip bracketA. #12 x 1%" screwsB. Anti-tip bracket4. Using a Phillips screwdriver, mount anti-tip bracket to the wallor floor with the two #12 x 1%" screws provided.Depending on the thickness of your flooring, longer screwsmay be necessary to anchor the bracket to the subfloor.Longer screws are available from your local hardware store.5. Move range close enough to opening to allow for electricalconnections to be made. Remove shipping base, cardboardor hardboard from under range.6. Continue installing your range using the following installationinstructions.10