Jenn-Air JES8850CAS02 Installation Instructions Manual

Also see for JES8750CAB00: Use & care guide

Contents

6. Completeinstallationfollowinginstructionsforyourtypeofelectricalconnection:4-wire(recommended)3-wire(if4-wireisnotavailable)ElectricalConnectionOptionsIf your home has: And you will be Go to Section:connecting to:4-wire receptacle A UL listed, 4-wire connection:(NEMA type 14-50R) 250-volt Power supply cordminimum,40-amp, rangepower supplycord4-wire direct A fused 4-wire connection:disconnect or Direct wirecircuit breakerbox(12.7 crn)3-wire receptacle A UL listed,(NEMA type 10-50R) 250-voltminimum,C_ 40-amp, rangepower supplycord3-wire connection:Power supply cord3-wire direct A fused1" disconnect or_-_/ circuit breakerbox3-wire connection:Direct wire4-wire connection: Power Supply CordUse this method for:• New branch-circuit installations (1996 NEC)• Mobile homes• Recreational vehicles• In an area where local codes prohibit grounding through theneutral1. Part of metal ground strap must be cut out and removed.2=A.! i _BCi .........A. Metal ground strapB. DiscardC. Ground-rink screwUse Phillips screwdriver to remove the ground-link screwfrom the back of the range. Save the ground-link screw andthe end of the ground link under the screw.3= Feed the power supply cord through the opening in the cord/conduit plate on bottom of range. Allow enough slack toeasily attach the wiring to the terminal block.CA. Terminal blockB. Ground-link screwC. Cord/conduit plateD. Power supply cord wiresD4. Use Phillips screwdriver to connect the green ground wirefrom the power supply cord to the range with the ground-linkscrew. The ground wire must be attached first.5. Use 3/8"nut driver to connect the neutral (white) wire to thecenter terminal block post with one of the 10-32 hex nuts.6=7.8=FCDA. 10-32 hex nutB. Ground-link screwC. Line 1 (black)D. Green ground wireE. Neutral (center) wireF. Line 2 (red)Connect line 1 (black) and line 2 (red) wires to the outerterminal block posts with 10-32 hex nuts.Securely tighten hex nuts.NOTE: For power supply cord replacement, only use a powercord rated at 250 volts minimum, 40 amps or 50 amps that ismarked for use with nominal 13/8"(3.5 cm) diameterconnection opening, with ring terminals and marked for usewith ranges.Replace terminal block access cover.10