Jenn-Air JFC2089HPR Use & Care Manual

Contents

Jenn-Air JFC2089HPR Use & Care Manual Manual pdf 5 page image

I NSTALLATI 0 NLevelingTo enhance the appearance and maintain performance,the refrigerator should be leveled per instructionsbelow.Door and Drawer RemovalSome installations require door/drawer removal totransport the refrigerator to its final location.Notes:• Complete any required water supply connectionbefore leveling.• Some models only have adjustment screws (A).Materials Needed:• %" hex head driver• Carpenter's level.1. Remove toe grille.• Grasp firmly and pull outward to unclip.2. Using hex head driver, turn the front adjustmentscrews (A) on each side to raise or lower the frontof the refrigerator (see illustration below).C C3. Using the hex head driver, turn each of theseadjustment screws (B) to raise or lower the rear ofthe refrigerator.4. Using a carpenter's level, make sure front ofrefrigerator is '/4" (6 ram) or '/2bubble higher thanback of refrigerator and that the refrigerator is levelfrom side to side.5. Turn stabilizing legs (C) clockwise until firmlyagainst floor.6. Turn adjustment screws (A) counterclockwise toallow the full weight of the refrigerator to rest onthe stabilizing legs.7. Replace the toe grille.• Align the toe grille mounting clips with the lowercabinet slots.• Push the toe grille firmly until it snaps into place.Materials Needed:• _6" hex head driver• Phillips screwdriver• 3/_,,hex head driver1. Unplug power cord from power source.2. Remove toe grille.3. Remove top hinge cover fromrefrigerator door by removing Phillipsscrew and retain screw and cover forlater use.. Unscrew -_,6"hex head screws from tophinge to remove hinge and retain allscrews for later use.Lift right side refrigerator door fromcenter hinge pin. Remove doorclosure from center hinge pin on theright side and retain for later use.Disconnect wire harness on topof left side refrigerator door tophinge.• Release two-pin connector bypressing junction point with aflat blade screwdriver orfingernail.• Green ground wire remainsattached to the hinge.7. Unscrew ?6" hex head screws from [[J<top hinge to remove hinge andretain for later use.8. Remove Phillips screws to "Iremove right and left hinges and IIretain all screws for later use.