Jenn-Air JFC2290VTB10 User Instructions

Also see for JFC2290VTB1: Dimensions and installation

Contents

Jenn-Air JFC2290VTB10 User Instructions Manual pdf 10 page image

Afterreplacingthewaterfilter,pressandholdResetFilterorFilterReset(dependingonyourmodel)forthreeseconds.TheOrderandReplaceindicatorlightswillblinkandthengooffwhenthesystemisreset.See"UsingtheControls."Replacing the Water FilterTo purchase a replacement water filter, model UKF8001AXX-750,contact your dealer or call 1-877-232-6771 U.S.A. or1-800-807-6777 Canada.IMPORTANT: Air trapped in the water system may cause waterand filter to eject. Always dispense water for at least 2 minutesbefore removing the filter or blue bypass cap.1. Turn filter counterclockwise to remove.2. Remove sealing label from replacement filter and insert thefilter end into the filter head.3. Turn the filter clockwise until it stops. Snap the filter coverclosed.NOTE: The dispenser feature may be used without a water filterinstalled. Your water will not be filtered. If this option is chosen,replace the filter with the blue bypass cap.REFRIGERATORCAREExplosion HazardUse nonflammable cleaner.Failure to do so can result in death, explosion, or fire.Both the refrigerator and freezer sections defrost automatically.However, clean both sections about once a month to avoidbuildup of odors. Wipe up spills immediately.IMPORTANT: Because air circulates between both sections, anyodors formed in one section will transfer to the other. You mustthoroughly clean both sections to eliminate odors. To avoid odortransfer and drying out of food, wrap or cover foods tightly.To Clean Your Refrigerator:NOTE: Do not use abrasive or harsh cleaners such as windowsprays, scouring cleansers, flammable fluids, cleaning waxes,concentrated detergents, bleaches or cleansers containingpetroleum products on plastic parts, interior and door liners orgaskets. Do not use paper towels, scouring pads, or other harshcleaning tools.1. Unplug refrigerator or disconnect power.2. Hand wash, rinse, and dry removable parts and interiorsurfaces thoroughly. Use a clean sponge or soft cloth and amild detergent in warm water.3. Wash stainless steel and painted metal exteriors with a cleansponge or soft cloth and a mild detergent in warm water.• To keep your stainless steel refrigerator looking like newand to remove minor scuffs or marks, it is suggested thatyou use the manufacturer's approved Stainless SteelCleaner and Polish, Part Number 20000008. To order thecleaner, call 1-877-232-6771 U.S.A. or 1-800-807-6777Canada.IMPORTANT: This cleaner is for stainless steel parts only!Do not allow the Stainless Steel Cleaner and Polish to comeinto contact with any plastic parts such as the trim pieces,dispenser covers or door gaskets. If unintentional contactdoes occur, clean plastic part with a sponge and milddetergent in warm water. Dry thoroughly with a soft cloth.4=5=There is no need for routine condenser cleaning in normalhome operating environments. If the environment isparticularly greasy or dusty, or there is significant pet traffic inthe home, the condenser should be cleaned every 2 to3 months to ensure maximum efficiency.If you need to clean the condenser:• Remove the base grille.• Use a vacuum cleaner with a soft brush to clean the grille,the open areas behind the grille and the front surface areaof the condenser.• Replace the base grille when finished.Plug in refrigerator or reconnect power.NOTE: Not all appliance bulbs will fit your refrigerator. Be sure toreplace the bulb with an appliance bulb of the same size, shape,and wattage (no greater than 40 watts).1=2.Changing the Refrigerator Light BulbUnplug the refrigerator or disconnect power.Slide the light shield toward the back of the compartment torelease it from the light assembly.3=4.Replace burned-out bulb(s) with appliance bulb(s) no greaterthan 40 watts.Replace the light shield by inserting the tabs on the shield intothe liner holes on each side of light assembly. Slide the shieldtoward the front until it locks into place.NOTE: To avoid damaging the light shield, do not force theshield beyond the locking point.5. Plug in refrigerator or reconnect power.Changing the Freezer Light Bulb1. Unplug refrigerator or disconnect power.2. Remove the burned-out bulb and replace it with an appliancebulb no greater than 40 watts.3. Plug in refrigerator or reconnect power.10