Jenn-Air JGC2536EB Installation Instructions Manual

Also see for JGC2536EB: Use & care guide

Contents

3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation.Tools needed■ Tape measure■ Flat-blade screwdriver■ 15⁄16" (24 mm) combinationwrench■ Pipe wrench■ Channel lock pliersParts supplied■ Gas pressure regulator■ Burner grates: common (4), center (1)■ Burner bases (5)■ Burner caps (5)■ Simmer cap■ Clamp brackets (2)■ 2¹⁄2" (6.4 cm) clamping screws (2)■ Foam tape seal■ LP conversion kit - W10686634Parts neededCheck local codes and consult gas supplier. Check existing gassupply and electrical supply. See “Electrical Requirements” and“Gas Supply Requirements” sections.Location RequirementsIMPORTANT: Observe all governing codes and ordinances. Donot obstruct flow of combustion and ventilation air.■ It is the installer’s responsibility to comply with installationclearances specified on the model/serial/rating plate. Themodel/serial/rating plate is located on the underside of thecooktop burner box.■ Do not unpack the burner grates and bases until after thecooktop is installed to avoid scratching the cooktop.■ To eliminate the risk of burns or fire by reaching over heatedsurface units, cabinet storage space located above thesurface units should be avoided. If cabinet storage is to beprovided, the risk can be reduced by installing a range hoodthat projects horizontally a minimum of 5" (12.7 cm) beyondthe bottom of the cabinets.■ The cooktop should be installed in a location away fromstrong draft areas, such as windows, doors and strongheating vents or fans.■ All openings in the wall or floor where cooktop is to beinstalled must be sealed.■ Cabinet opening dimensions that are shown must be used.Given dimensions are minimum clearances.■ Grounded electrical supply is required. See “ElectricalRequirements” section.■ Proper gas supply connection must be available. See “GasSupply Requirements” section.■ The gas and electric supply should be located as shown in“Gas and Electric Connection Locations” in the “LocationRequirements” section so that they are accessible withoutrequiring removal of the cooktop.■ Marker or pencil■ Pipe-joint compoundresistant to LP gas■ Noncorrosive leak-detectionsolutionIMPORTANT: To avoid damage to your cabinets, check withyour builder or cabinet supplier to make sure that the materialsused will not discolor, delaminate or sustain other damage.Mobile Home - Additional Installation RequirementsThe installation of this cooktop must conform to theManufactured Home Construction and Safety Standard, Title 24CFR, Part 3280 (formerly the Federal Standard for Mobile HomeConstruction and Safety, Title 24, HUD Part 280). When suchstandard is not applicable, use the Standard for ManufacturedHome Installations, ANSI A225.1/NFPA 501A or with local codes.In Canada, the installation of this cooktop must conform with thecurrent standards CAN/CSA-A240-latest edition, or with localcodes.Product DimensionsA. *21" (53.3 cm)B. *30" (76.2 cm) on 30" (76.2 cm) models36" (91.4 cm) on 36" (91.4 cm) modelsC. 31/4" (8.3 cm)*Metal tabs should not be bent during installationGas and Electric Connection LocationsA. Gas pressure regulator (supplied) - arrow pointedtoward cooktopB. 3 prong grounding type outlet with correct polarityC. Gas shutoff valveD. 18" (45.7 cm) minimumA BCCABD