18. Set the control console back into place on the cooktop. For aproper fit, the flange of the control console must hook overthe lip on the front of the cooktop.19. Check that the control console is flush with the top edge ofthe cooktop.BA. Control console flangeB. Front lip of range cooktopA. Flush with top of cooktop20. Replace the 2 screws on each side of the control console.21. Push the cooktop back into place in the cutout.22. Replace the control knobs.23. Replace burner grates.24. Plug in cooktop or reconnect power.25. Test the flame by turning the control from LO to HI, checkingthe flame at each setting.GAS CONVERSIONSIMPORTANT: Gas conversions from Natural gas to LP gas mustbe done by a qualified installer.Explosion HazardUse a new CSA International approved gas supply line.Install a shut=off valve.Securely tighten all gas connections.if connected to LP, have a qualified person make suregas pressure does not exceed 14" (36 cm) watercolumn.Examples of a qualified person include:licensed heating personnel,authorized gas company personnel, andauthorized service personnel.Failure to do so can result in death, explosion, or fire.1. Turn the manual shutoff valve to the closed position........... ..................SA_J .............. .....................CA. To cooktopB. Shutoff valve (closed position)C. Gas supply line2. Unplug cooktop or disconnect power.To Convert Gas Pressure Regulator1. Remove the access cap by using a wrench, turning theaccess cap counterclockwise.2. Remove spring retainer from the cap by pushing against theflat side of the spring retainer. Look at the spring retainer tolocate the "NAT" or "LP" position. Turn over the springretainer so the "LP" is showing on the bottom. Snap thespring retainer back into the cap. Reinstall the cap onto theregulator.jiJ_A T, BE D CA. Access cap D. LP positionB. Gasket E. NAT positionC. Gas pressure regulator11