Jenn-Air JGD3536BS00 Installation Instructions Manual

Calculating Vent System LengthTo calculate the length of the system you need, add theequivalent feet (meters) for each vent piece used in the system.Vent Piece 6" (15.2 cm) Round45 ° elbow 2.5 ft(0.8 m)90 ° elbow 5.0 ft(1.5 m)6" (15.2 cm) 0.0 ftwall cap (0.0 m)31/4"x 10" (8.3 cm x 25.4 cm) 4.5 ftto 6" (15.2 cm) transition (1.4 m)6" (15.2 cm) to 31/4'' x 10" 1 ft(8.3 cm x 25.4 cm) transition (0.3 m)31/4"x 10" (8.3 cm x 25.4 cm) 5.0 ftto 6" (15.2 cm) 90 ° elbow (1.5 m)transition6" (15.2 cm) to 31/4'' x 10" 5.0 ft(8.3 cm x 25.4 cm) 90 ° elbow (1.5 m)transition31/4"x 10" (8.3 cm x 25.4 cm) 5.0 ft90 ° elbow (1.5 m)31/4"x 10" (8.3 cm x 25.4 cm) 12.0 ftflat elbow (3.7 m)31/4'' x 10" (8.3 cm x 25.4 cm) 0.0 ftwall cap (0.0 m)Example vent system90 ° embow1- 90 ° elbow8 ft (2.4 m) straight1 - wall capSystem length6 ft (1.8m)= 5 ft (1.5 m)= 8 ft (2.4 m)= 0 ft (0 m)= 13 ft (3.9 m)wall capUNOTE: Flexible vent is not recommended. Flexible vent createsback pressure and air turbulence that greatly reduceperformance.IMPORTANT: The cooktop must be electrically grounded inaccordance with local codes and ordinances, or in the absenceof local codes, with the National Electrical Code, ANSl/NFPA 70or Canadian Electrical Code, CSA C22.1.This cooktop is equipped with an electronic ignition system thatwill not operate if plugged into an outlet that is not properlypolarized.If codes permit and a separate ground wire is used, it isrecommended that a qualified electrical installer determine thatthe ground path is adequate.A copy of the above code standards can be obtained from:National Fire Protection Association1 Batterymarch ParkQuincy, MA 02169-7471CSA International8501 East Pleasant Valley RoadCleveland, Ohio 44131-5575• A 120 volt, 60 Hz, AC only, 15-amp, fused electrical circuit isrequired. A time-delay fuse or circuit breaker is alsorecommended. It is recommended that a separate circuitserving only this cooktop be provided.• Electronic ignition systems operate within wide voltage limits,but proper grounding and polarity are necessary. Check thatthe outlet provides 120-volt power and is correctly grounded.• The wiring diagrams are provided with this cooktop. See"Wiring Diagrams" on a separate sheet. The wiring diagramsare located on the left underside of the cooktop base.