Jenn-Air JS42NXFXDW Installation Manual

Also see for JS42NXFXDW: Design and planning guide Installation instructions Installation guide Installation guide Installation guide

Contents

Jenn-Air JS42NXFXDW Installation Manual Manual pdf 14 page image

14Standard Grille Installation—Flush Grille—Open orClosed SoffitIMPORTANT: The grille panel height, shown in the “StandardIntegrated Grille Installation—Side View” graphic, allows for an airgap critical to refrigerator performance.INSTALLATIONINSTRUCTIONSUnpack the RefrigeratorIMPORTANT:■ Do not remove the film covering until the refrigerator is in itsoperating location.■ All four leveling legs must contact the floor to support andstabilize the full weight of the refrigerator.■ Keep the cardboard shipping piece or plywood under therefrigerator until it is installed in the operating location.1. Remove and save the literature package and hardware kitlocated inside the refrigerator. Remove and save the literature,grille, and trim taped to the outside of the refrigerator.NOTE: Do not remove tape and door bracing until therefrigerator is in its final location.Move the Refrigerator into House1. Place an appliance dolly under the left side of the refrigeratoras shown. Place the corner posts from the packing materialsover the trims as appropriate. Slowly tighten the strap.2. Place pieces of the shipping carton on the floor when rollingthe dolly and refrigerator into the house. Move the refrigeratorclose to the built-in opening.3. Place top of cardboard carton or plywood under refrigerator.4. Stand the refrigerator up. First, place the left bottom edge ofthe refrigerator on the floor, stand the refrigerator upright andthen lower the right-hand side of the refrigerator to the floor.5. Reassemble the trim and top grille after the dolly has beenremoved from the refrigerator.Install Anti-Tip BoardsIMPORTANT:■ If a solid soffit is not available, anti-tip boards must beinstalled.■ It is recommended that boards be installed before therefrigerator is installed.■ Boards must be long enough to fully cover the width of thecompressor cover.■ Place the boards so that the bottom surfaces of the boardsare 84" (213 cm) from the floor.■ During installation, raise the refrigerator up until the top of therefrigerator is making contact with the bottom of the anti-tipboards. Do not crush the compressor cover when raising therear leveling legs.Model 42 48Reveal ³⁄₈" ¹⁄₈" ³⁄₈" ¹⁄₈"D 41¹⁄₄"(104.78 cm)41³⁄₄"(106.05 cm)47¹⁄₄"(120.02 cm)47³⁄₄"(121.29 cm)E 41¹⁄₄"(104.78 cm)41³⁄₄"(106.05 cm)47¹⁄₄"(120.02 cm)47³⁄₄"(121.29 cm)E5³⁄₄"(14.55 cm) Top Grille PanelD1" (2.54 cm) Top Grille FillerWARNINGTip Over HazardRefrigerator is top heavy and tips easily when notcompletely installed.Keep doors taped closed until refrigerator iscompletely installed.Use two or more people to move and installrefrigerator.Failure to do so can result in death or serious injury.WARNINGTip Over HazardRefrigerator is top heavy and tips easily when notcompletely installed.Keep doors taped closed until refrigerator iscompletely installed.Use two or more people to move and installrefrigerator.Failure to do so can result in death or serious injury.