Jenn-Air JUB248LBCX00 Use & Care Manual

Contents

Jenn-Air JUB248LBCX00 Use & Care Manual Manual pdf 7 page image

Install the DoorIMPORTANT: To ensure proper operation, be sure to grease thetop hinge, top spacer and washer with petroleum jelly.1. Using a Phillips screwdriver and three screws, attach the topspacer to the door.2. Using petroleum jelly, grease the bottom spacer hole and thebottom hinge pin. Align the washer with the bottom spacerhole.3. Slowly lower the door straight and evenly onto the bottomhinge pin. Be sure the washer stays in place. Close the door.Be sure the door properly aligns to the cabinet.NOTE: Provide additional support for the door when movingthe hinges. Do not depend on the door magnets to hold thedoor in place while you are working.4. Using masking tape, secure the door to the cabinet beforeinstalling the top spacer as shown.7. Remove the masking tape from the door.Door ClosingYour beverage center has four leveling legs. If your beveragecenter seems unsteady or you want the door to close more easily,adjust the beverage center's tilt using the instructions below.Electrical Shock HazardPlug into a grounded 3 prong outlet.Do not remove ground prong.Do not use an adapter.Do not use an extension cord,Failure to follow these instructions can result in death,fire, or electrical shock.1. Plug into a grounded 3 prong outlet.A. Top spacerB. Masking tape5. Place the washer on the top spacer and align the holes.Grease the top hinge pin, top spacer and washer withpetroleum jelly. Insert the top hinge pin into the washer andtop spacer.6. Using a Phillips screwdriver and three screws, attach the tophinge to the cabinet as shown.A AC1 ,I...............................iA. Screws (3) D. Top spacerB. Top Hinge E. DoorC. Washer F Overlay frame2.3.4=Excessive Weight HazardUse two or more people to move and installbeverage center.Failure to do so can result in back or other injury.Move the beverage center into its final location.Turn the leveling legs to the right to lower the beverage centeror turn the leveling legs to the left to raise it. It may takeseveral turns of the leveling legs to adjust the tilt of thebeverage center.NOTE: Having someone push against the top of the beveragecenter takes some weight off the leveling legs. This makes iteasier to adjust the leveling legs.Open the door and check to make sure that it closes as easilyas you like. If not, tilt the beverage center slightly more to therear by turning both front leveling screws to the right. It maytake several more turns, and you should turn both levelinglegs the same amount.