Jenn-Air JXT5830ADB Service

Contents

Jenn-Air JXT5830ADB Service Manual pdf 14 page image

14 16023510 ©2004 Maytag ServicesWARNING! To avoid risk of electrical shock, personal injury ordeath; disconnect power to unit before servicing.Disassembly ProceduresCapacitor Removal1. Disconnect power to vent hood.2. Remove grease filters and covers, see "Grease Filter/Grease Filter Cover Removal" procedure.3. Remove light panel, see "Light Panel Removal"procedure.4. Discharge capacitor by connecting a one end of ajumper wire to the capacitor terminal with the diodeconnection and the other end to a well insulatedscrewdriver. Touch the screwdriver to a chassisground. Remove jumper wire.5. Remove screws securing capacitor.6. Label and disconnect capacitor electrical connectionsand remove capacitor.7. Reverse procedure to reinstall capacitor.Light Panel Removal1. Disconnect power to vent hood.2. Remove grease filters and covers, see "Grease Filter/Grease Filter Cover Removal" procedure.3. Remove screws securing light panel.NOTE: Some screws are located on top of light panel.4. Remove screws securing blower motor cover.5. Label and disconnect fan switch wires.6. Remove light socket, see "Light Socket Removal"procedure.7. Angle the light panel slightly and gently pull down toremove from vent hood.8. Reverse procedure to reinstall light panel.Control Board Removal1. Disconnect power to vent hood.2. Remove grease filters and covers, see "Grease Filter/Grease Filter Cover Removal" procedure.3. Remove screws securing light panel.4. Slide panel towards rear of vent hood.5. Remove light panel, see "Light Panel Removal"procedure.6. Label and disconnect control board wiring andremove control board.7. Reverse procedure to reinstall control board.Touch Pad Removal1. Disconnect power to vent hood.2. Remove grease filters and covers, see "Grease Filter/Grease Filter Cover Removal" procedure.3. Remove light panel, see "Light Panel Removal"procedure.4. Remove screws securing touch pad.5. Label and disconnect touch pad electricalconnections.6. Rotate and remove touch pad from base.7. Reverse procedure to reinstall touch pad.