Jenn-Air JXU9130WP Installation Instructions And Use & Care Manual

Also see for JXU9130WP: Design and planning guide Use & care guide Installation Instructions and Use & Care Guide

Jenn-Air JXU9130WP Installation Instructions And Use & Care Manual Manual pdf 11 page image

11RANGE HOOD CARECleaningIMPORTANT: Clean the hood and grease filters frequentlyaccording to the following instructions. Replace grease filtersbefore operating hood.Exterior Surfaces:To avoid damage to the exterior surface, do not use steel wool orsoap-filled scouring pads.Always wipe dry to avoid water marks.Cleaning Method:■ Liquid detergent soap and water, or all-purpose cleanser■ Wipe with damp soft cloth or nonabrasive sponge, then rinsewith clean water and wipe dry.Metal Grease FilterTo Remove Metal Grease Filters:1. Use 2 hands to remove the metal grease filters. Grasp filterhandles, push toward the rear of the range hood and pulldown on the front handle to remove.2. Repeat for each grease filter.3. Wash metal grease filters as needed in a dishwasher or handwash in a hot detergent solution to clean.To Reinstall Metal Grease Filters:1. Grasp filter handles and place rear of filter into rear track.2. Push down on the rear handle and set the front of the greasefilter into the front track to secure.3. Repeat for each filter.Replacing a Halogen LampTurn off the range hood and allow the halogen lamp to cool. Toavoid damage or decreasing the life of the new bulb, do nottouch bulb with bare fingers. Replace bulb, using tissue orwearing cotton gloves to handle bulb.If new lamps do not operate, make sure the lamps are insertedcorrectly before calling service.1. Disconnect power.2. Push up on the lens and turn it counterclockwise.3. Remove the bulb and replace it with a 120-volt, 50-wattmaximum halogen bulb with a GU10 base. Turn it clockwiseto lock it into place.4. Repeat steps 2-3 for the other bulb if needed.5. Reconnect power.