Jenn-Air JXW8836WS0 Installation Instructions And Use & Care Manual

Also see for JXW8230WS: Installation Instructions and Use & Care Guide

Contents

Jenn-Air JXW8836WS0 Installation Instructions And Use & Care Manual Manual pdf 10 page image

8. Sealconnectionswithventclamps.Electrical Shock HazardPlug into a grounded 3 prong outlet.Do not remove ground prong.Do not use an adapter.Do not use an extension cord.Failure to folow these instructions can result in death,fire, or electrical shock.9. Plug 3 prong power cord into a grounded 3 prong outletlocated above the range hood.n CWhen using both upper and lower vent covers, push lower coverdown onto hood and lift upper cover to ceiling and install withtwo 2.9 x 6.5 mm screws.NOTE: For vented installations, the upper vent cover may bereversed to hide slots.A. Upper vent coverB. Lower vent coverC. 2.9 x 6.5 mm screwsD. BracketRANGE HOOD USEThe range hood is designed to remove smoke, cooking vaporsand odors from the cooktop area. For best results, start the hoodbefore cooking and allow it to operate several minutes after thecooking is complete to clear all smoke and odors from thekitchen.The range hood controls are located on the front side of thecanopy.\GDA. Louver holes (non-vented[recirculating] installations only)B.Duct coversC. CanopyD. Grease filtersE. Lamp housingsF. Grease filter handlesG. Control panelControl PanelThe range hood controls are located on the front side of thecanopy.A B C D E[_o......................:_ IIJENN-AIR BSBBQ Clean grease fll erA. Power decreaseB. Power increaseC. DisplayD. LightE. Timer1. For non-vented (recirculating) installations only, installcharcoal filters over grille on blower housing. See the "RangeHood Care" section.2. Install metal filters. See the "Range Hood Care" section.3. Check the operation of the range hood blower and light. Seethe "Range Hood Use" section.NOTE: To get the most efficient use from your new range hood,read the "Range Hood Use" section.Grease Filter Saturation AlarmAfter 30 hours of fan function, the display will show "CleanGrease Filter" when the fan is active. When this icon shows in thedisplay, the installed grease filters should be washed. See"Range Hood Care" section.• To reset the grease filter saturation alarm, press and hold thePOWER INCREASE button for 5 seconds. The "Clean GreaseFilter" icon will no longer be displayed.10