14Backer PanelsNOTES:■ Dashed lines represent backer panel placement.■ Illustration shows backer panels placed on decorativeoverlays.Dispenser Frame (dispenser models only)The dispenser frame attaches to the panel with 4 screws.The dispenser frame overlaps the dispenser cutout by ⁵⁄₁₆"(0.78 cm) on each side and ¹⁄₂" (1.27 cm) on the top and bottom.Euro-Style and Pro-Style®Custom Side PanelsCustom side panels may be needed when not enough space isavailable to have cabinets on both sides of the refrigerator orwhen the refrigerator is placed at the end of a cabinet run. Youmay choose an Inset, Flush, or Recessed Inset panel installation.Refrigerator and Side Trim DimensionsThe width and height of a side panel are determined by the type ofinstallation you are planning.NOTES:■ The dimensions shown are actual product dimensions andmay not reflect the needed panel installation dimensions.■ The side panel should be a minimum of ½" (1.27 cm) thickto avoid warping.■ If the opening depth is 25" (63.5 cm) or more, you maywant to install a support board on rear wall.Model A B C42 16³/₄" (42.55 cm) 22³/₄" (57.79 cm) 39³/₄" (100.97 cm)48 19¹/₄" (48.90 cm) 26¹/₄" (66.68 cm) 45³/₄" (116.21 cm)Bottom Offset¹⁄₈" (3.2 mm)Bottom Offset¹⁄₈" (3.2 mm)AA BAC6³⁄₁₆"(15.7 cm) Side Offset¹⁄₂" (12.7 mm)Top Offset1⁵⁄₈" (4.13 cm)Bottom Offset¹⁄₂" (1.27 cm)22"(55.9 cm)33¹⁄₄"(84.5 cm)70¹⁄₂"(179.1 cm)70¹⁄₂"(179.1 cm)Handle-Side Offset¹⁄₄"(6.4 mm)A. Decorative panelB. Refrigerator doorC. Dispenser frameA.¹⁄₂" (1.27 cm) OverlapABCAA
