Jenn-Air W10276304A User Instructions

13■ Is the water pressure at least 35 psi (241 kPa)? The waterpressure to the home determines the flow from the dispenser.See “Water Supply Requirements.”■ Water filter installed on the refrigerator? Remove filter andoperate dispenser. If water flow increases, the filter may beclogged or incorrectly installed. Replace filter or reinstall itcorrectly.■ Refrigerator door closed completely? Close the doorfirmly. If it does not close completely, see “The doors will notclose completely,” earlier in this section.■ Recently removed the doors? Make sure the waterdispenser wire/tube assembly has been properlyreconnected. See “Refrigerator Door(s) and Drawer.”■ Reverse osmosis water filtration system connected toyour cold water supply? This can decrease water pressure.See “Water Supply Requirements.”Water is leaking from the dispenser systemNOTE: One or two drops of water after dispensing is normal.■ Glass not being held under the dispenser long enough?Hold the glass under the dispenser 2 to 3 seconds afterreleasing the dispenser lever.■ New installation? Flush the water system. See “WaterDispenser.”■ Recently changed water filter? Flush the water system. See“Water Dispenser.”■ Water on the floor near the base grille? Make sure thewater dispenser tube connections are fully tightened. See“Refrigerator Door(s) and Drawer.”Water from the dispenser is warmNOTE: Water from the dispenser is only chilled to 50°F (10°C).■ New installation? Allow 24 hours after installation for thewater supply to cool completely.■ Recently dispensed large amount of water? Allow24 hours for water supply to cool completely.■ Water not been recently dispensed? The first glass of watermay not be cool. Discard the first glass of water.■ Refrigerator connected to a cold water pipe? Make surethe refrigerator is connected to a cold water pipe. See “WaterSupply Requirements.”WATER FILTER CERTIFICATIONS