26Install Handles(Panel Kit Models Only)IMPORTANT: Install the handles after the door panels have beeninstalled. Follow the instructions specific to your door paneldesign.Tools Needed: ³⁄₃₂" Allen wrenchDoor Panels - Custom Wood, Stainless Steel andOiled Bronze Designs1. Locate the holes in the door panels where the handlemounting studs are to be installed.2. Fasten the handle mounting studs to the door panels.3. Install the handles to the handle mounting studs and tightenthe setscrews.Door Panels - Floating Glass DesignIMPORTANT: To align the handle correctly on the door, the plastichandle spacer and the setscrews on the door handle must be inthe positions designated in the chart.1. Locate the holes in the door panels where the handlemounting studs are to be installed.2. Insert the circular post on the back of the handle spacers intothe holes in the door panels.3. Depending on your model and the compartment, rotate theplastic spacer so that the curved handle mounting posts areeither at the top, bottom or to the left. See following chart.4. Slide the screw into the handle mounting stud. Insert thescrew assembly into the center hole of the plastic spacer andfasten it to the door panel.5. Install the handles to the handle mounting studs so that thesetscrews are on the designated side and tighten thesetscrews.Install Base GrilleThere are two pieces to the base grille to allow for a custom fit: thebase grille itself and the skirt. The skirt can be added to the basegrille in order to extend it all the way to the floor.1. To see whether the skirt is needed, place the base grille intoposition. Do not attach the base grille to the refrigerator.Measure the distance between the bottom of the base grilleand the floor. The gap must be a minimum of ¹⁄₂" (1.27 cm) inorder to add the skirt.NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skipsteps 3 and 4 of the instructions, and install the base grilleonly.2. Remove the film from the base grille.3. Snap the skirt onto the base grille.4. Trim the skirt by scoring the proper “V” groove with a utilityknife. Break the skirt at the score line.5. Using the two screws, attach the base grille assembly to therefrigerator as shown.NOTE: Drive in the right side screw first.A. Plastic handle spacerB. Straight handle mounting postsC. Curved handle mounting postsD. Circular postBottom Mount French DoorBottom MountBothModelsRefrigerator Refrigerator FreezerLeftSwingRightSwingLeftDoorRightDoor DrawerCurvedMountingPostBottom Top Bottom Top LeftSetscrews Right Left Right Left DownA B DCB CA. Base grilleB. SkirtA. “V” grooveA. Screws (2)ABAA