Jensen POWER 400 - POWER 400 AMPLIFIER Installation And Operation Manual

Jensen POWER 400 - POWER 400 AMPLIFIER Installation And Operation Manual Manual pdf 12 page image

POWER Amplifiers10Indicators and ControlsPower Indicator (POWER)The power indicator provides a visual indication that the amplifier is turned on.Input Level Control (LEVEL)The input LEVEL control matches the output of your radio to the input of theamplifier. After the installation is complete, make sure the input level control onthe amplifier is turned down all the way (counter-clockwise or all the way to theleft). Play a tape or CD (make sure bass and treble settings or Bass EQ areflat) and turn the volume up slowly until you just start to hear distortion. Backthe volume down just a bit. On the amplifier, slowly turn up the input levelcontrol (clockwise or to the right) until you just start to hear distortion, thenback it down a bit. Now your radio and amplifier levels are matched.BASS EQThe Bass EQ is continuously adjustable from 0 to +12dB @ 45Hz. Adjustingthe Bass Boost level allows different subwoofer/enclosure combinations to beequalized. Use this control to increase the level of low bass available from yoursubwoofer/enclosure combination. Ported and Band Pass enclosures shouldbe limited to about +6dB to +9dB of boost. Sealed enclosures should be ableto accept the full +12dB of boost, if necessary. The full +12dB of boost shouldbe reserved for special applications since improper use of the Bass Boostcould damage your subwoofers at high volumes.Low Pass Filter (LPF)The Low Pass Filter controls adjust the crossover point. Typical crossover isbetween 60Hz and 80Hz for ported and sealed enclosures. Bandpass boxeswill typically use a higher crossover setting between 125Hz and 150Hz. Sincemusical tastes vary, you should play music that you would normally listen to inyour vehicle, with the above settings as a starting point. If necessary, set thecrossover by ear.High Pass Filter (HPF)The high pass filter will limit the low frequencies being transmitted to yourspeakers. This can be useful in number of situations. For example, if youselected the high pass filter and set the crossover to 40Hz, then you wouldhave an infra-sonic (sub-sonic) filter at 40Hz, which would be useful withcertain enclosure/subwoofer combinations that were tuned between 45Hz and50Hz. Other uses might include limiting the low frequencies to smallerspeakers (6 1/2", 6 X 9", etc.) by adjusting the crossover to a higher setting(80–100Hz).Crossover (X-OVER)The Jensen Power series of amplifiers have built-in low-pass and high-passcrossover filters for bi-amplifying the system. Adjust the crossover toaccommodate your chosen installation method. Select LPF (low pass filter)when the amplifier will be driving woofers or subwoofers. Choose FULL whencrossover mode is not active and the amplifier is in “full range” mode. SelectHPF (high pass filter) when the amplifier will be driving full-range or separatespeakers, and you want to limit the “bass” being transferred to these speakers.Mode SwitchPower 400.2The 400.2 comes equiped with a MONO/STEREO MODE switch. UseSTEREO mode when you have a 2-channel input from the source unit. UseMONO mode when you have a single input from the source unit. See “InputWiring” on page 8.Power 760.4The 760.4 comes equiped with a 2/3/4 MODE switch and can be configured forthree different input modes: 2 channel, 3 channel or 4 channel.