15AiPod+SD1513What’s in the BoxSD1513 Head UnitCosmetic Trim RingWiring Harness Power/SpeakerMounting HardwareRemote ControljLink iPod Cable3.5mm Media CableOwners ManualInstallation Guide•••••••••Tools and SuppliesYou will need these tools and supplies to install yourSD1513:Torx type, fl at-head and Philips screwdriversWire cutters and strippersTools to remove existing radio (screwdriver,socket wrench set or other tools)Electrical tapeCrimping toolVolt meter/test lightCrimp connections18 gauge wire for power connections16 – 18 gauge speaker wire•••••••••Installation GuideWARNING! Never install this unit where operation and viewing could interfere with safe drivingconditions.Wiring DiagramIMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or havethe installation handled by an experienced technician.Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.NOTE: When replacing afuse, make sure the newfuse is the correct typeand amperage. Usingan incorrect fuse coulddamage the radio. Thishead unit uses one 15amp fuse located belowthe wiring connector (15amp fast blow ATO).Power Antenna (dark blue wire) Connectto the power antenna or an amplifi er. If notused, tape the bare end of wire.Accessory/Ignition (red wire)Connect to the existing radio wire or radiofuse.Ground (black wire)Connect to the ground terminal or aclean, unpainted part of the chassis.Memory/Battery (yellow wire)Connect to the battery or to a 12 voltpower source that is always live. The radiowill not work if this wire is not connected.AntennaRCA Outputs to AmplifierLeft Front SpeakerRight Front SpeakerLeft Rear SpeakerRight Rear SpeakerDark BlueBlackYellowRedGreyGrey/Black (-)Grey (+)White/Black (-)White (+)Violet/Black (-)Violet (+)Green/Black (-)Green (+)15 Amp FuseSERIESSubwooferOutputiPod/jLink connectorUse this 8-pin DIN socket toconnect your jLink iPod cable.jLinkiPod CableAUX INSD1513