Jensen CD1213 Installation Manual

Also see for MP1313: Owner's manual

Jensen CD1213 Installation Manual Manual pdf 1 page image

CD1213What’s in the BoxCD1213 Head UnitCosmetic Trim RingWiring Harness Power/SpeakerMounting HardwareRemote Control3.5mm Media CableOwners ManualInstallation Guide••••••••Tools and SuppliesYou will need these tools and supplies to install yourCD1213:Torx type, flat-head and Philips screwdriversWire cutters and strippersTools to remove existing radio (screwdriver,socket wrench set or other tools)Electrical tapeCrimping toolVolt meter/test lightCrimp connections18 gauge wire for power connections16 – 18 gauge speaker wire•••••••••Installation GuideWARNING! Never install this unit where operation and viewing could interfere with safe drivingconditions.AUX INCD1213+15Wiring DiagramIMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or havethe installation handled by an experienced technician.Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.NOTE: When replacing afuse, make sure the newfuse is the correct typeand amperage. Usingan incorrect fuse coulddamage the radio. Thishead unit uses one 15amp fuse located belowthe wiring connector (15amp fast blow ATO).Power Antenna (dark blue wire) Connect tothe power antenna or an amplifier. If not used,tape the bare end of wire.Accessory/Ignition (red wire)Connect to the existing radio wire or radio fuse.Ground (black wire)Connect to the ground terminal or a clean,unpainted part of the chassis.Memory/Battery (yellow wire)Connect to the battery or to a 12 volt powersource that is always live. The radio will notwork if this wire is not connected.AntennaRCA Outputs to Amplifi erLeft Front SpeakerRight Front SpeakerLeft Rear SpeakerRight Rear SpeakerDark BlueBlackYellowRedGreyGrey/Black (-)Grey (+)White/Black (-)White (+)Violet/Black (-)Violet (+)Green/Black (-)Green (+)15 Amp FuseSERIES

/ 2

Related manuals for Jensen MP1313