Operating Instructions16” x 40” CNC LatheModel CL-1640ZXWALTER MEIER (Manufacturing) Inc.427 New Sanford RoadLaVergne, TN 37086 Part No. M-320930Ph.: 800-274-6848 Revision A 9/09www.waltermeier.com Copyright © 2009 Walter Meier (Manufacturing),Inc.

operating instructions

Warranty and Service

Warning

Introduction

Specifications

Unpacking

Uncrating and Set-Up

Electrical Connections

Coolant Preparation

Spindle

Adjustments

Aligning Tailstock to Headstock

Gap Section

Pre-Operation Inspection

Operating Controls

Jet CL-1640ZX Operating Instructions Manual

CL-1640ZX


Contents operating instructions Warranty and Service Table Of Contents Warning Introduction Specifications Unpacking Uncrating and Set-Up Electrical Connections Coolant Preparation Spindle Adjustments Aligning Tailstock to Headstock Gap Section Pre-Operation Inspection Operating Controls	Operating Instructions16” x 40” CNC LatheModel CL-1640ZXWALTER MEIER (Manufacturing) Inc.427 New Sanford RoadLaVergne, TN 37086 Part No. M-320930Ph.: 800-274-6848 Revision A 9/09www.waltermeier.com Copyright © 2009 Walter Meier (Manufacturing),Inc. Next / 56