Jet HVBS-56M Operating Instructions And Parts Manual

Also see for HVBS-56M: Brochure Owner's manual Operating instructions and parts manual

Jet HVBS-56M Operating Instructions And Parts Manual Manual pdf 6 page image

65.0 Setup and assemblyRead and understand allinstructions before attempting assembly. BandSaw must be disconnected from power duringall assembly procedures. Failure to comply maycause serious injury.5.1 Shipping contentsSee Figures 1 and 2.1 Band saw (not shown)1 Pulley cover – A2 Wheels – B2 Adjustable foot with nuts and washer – C1 Vertical cutting plate – D1 Vertical cutting plate stand – E1 Open end wrench 12/14mm – F1 Work stop assembly – G1 Handle – H1 Belt – I1 Handwheel –J1 Axle – K1 Stand shelf – L2 Stand cross braces – M1 Stand front panel – N4 Stand legs (2 LH, 2 RH) – O1 Hardware package, includes:19 Phillips hd screws, 1/4x5/8 – HP15 Socket hd cap screws, 1/4x1-1/4 – HP22 Cotter pins, 1/8x1 – HP36 Flat washers, 5/8 – HP424 Flat washers, 1/4 – HP525 Hex nuts, 1/4 – HP61 Flat head screw, 1/4 x 3/4 – HP7Figure 1(Hardware package p/n HVBS56MG-HP)5.2 Tools required for assemblyWrenches, 10mm, 12mmHex key, 4mm#2 cross point screwdriverPliers(Note: Ratchets and sockets will speed assembly.)5.3 Unpacking and cleanup1. Inspect all contents for shipping damage.Compare contents of shipping carton withcontents list in this manual. Report any damageor part shortages to your distributor.2. Do not discard packing material until saw isassembled and running properly.3. Remove rust protectant from exposed surfaces,such as bed, vise assembly, etc., with a cleanrag and cleaner/degreaser. Apply a light coat ofoil on these surfaces to inhibit rust.Figure 2