Jet HVBS-56M Owner's Manual

Also see for HVBS-56M: Brochure Operating instructions and parts manual Operating instructions and parts manual

Contents

Jet HVBS-56M Owner's Manual Manual pdf 5 page image

5Unpacking and Clean-UpNote: Read and understand the entire manualbefore attempting setup or operation.1. Remove all contents form the shippingcarton.2. Inspect contents for shipping damage andreport any damage to your distributor.3. Wipe bed and vise assembly with cleancloth to remove excess oil used to preventrust.4. Do not discard any packing material untilsaw has been assembled and is runningproperly.Tools Supplied for Assembly1. Wrench 12/14mmTools Required for Assembly• #2 Cross Point Screwdriver• 6-8" Adjustable Wrench or Wrench Set• Pliers - Regular or Needle Nose• 4mm Angle Hex Wrench• Ratchet and Sockets will Speed AssemblyAssembly1. With the help of another person turn the sawover so that it rests on the motor and sawbow, Figure 1. Place it on a piece ofcardboard, or a surface that will not damagethe saw.2. Attach a cross brace (A, Fig. 1) to the motorside of the bed using three 5/16”x1” hex capbolts, six 5/16” flat washers, and secure withthree 5/16” hex nuts. Hint: Tighten the nut(B, Fig. 1) on the end of the bed firstfollowed by the nuts on the sides.3. Attach a leg to the cross brace using four5/16”x3/4” carriage bolts, four 5/16” flatwashers and four 5/16” hex nuts. Use a12mm wrench to tighten. Repeat for otherleg.4. Remove the brace (C, Fig. 1) on theopposite end of the bed and bow using a10mm wrench.