6IntroductionThis manual is provided by WMH Tool Group covering the safe operation and maintenance proceduresfor the JET Model J-2210 and J-2230 Drill Presses. This manual contains instructions on installation,safety precautions, general operating procedures, maintenance instructions and parts breakdown. Thismachine has been designed and constructed to provide years of trouble free operation if used inaccordance with instructions set forth in this manual. If there are any questions or comments, pleasecontact either your local supplier or WMH Tool Group. WMH Tool Group can also be reached at our website: www.wmhtoolgroup.com.SpecificationsModel:.....................................................................J-2210 ......................... J-2230-2 ......................J-2230-4Stock Number .......................................................354205 ............................354206 ........................ 354207Motor ...................................................... 2HP, 1Ph, 230V ..............2HP, 3Ph, 230V .......... 2HP, 3Ph, 460VDrilling Capacity (in.)Cast Iron............................................................1-1/4 ............................... 1-1/4 ............................1-1/4Steel ..................................................................1-1/8 ............................... 1-1/8 ............................1-1/8Column Diameter (in.) .............................................4-5/16 ............................. 4-5/16 ..........................4-5/16Maximum Dimension Spindle to Column (in.)...............11 ....................................11 ................................ 11Spindle Taper........................................................... MT-3 ............................... MT-3 ............................MT-3Spindle Travel (in.) ..........................................................5 ......................................5 .................................. 5Spindle Dimension to Base (in.)..............................46-1/2 ............................. 46-1/2 ..........................46-1/2Spindle Dimension to Table (in.).............................32-3/4 ............................. 32-3/4 ..........................32-3/4Table Size (in.) ..........................................16-1/8 x 19-1/4 ............... 16-1/8 x 19-1/4 ............16-1/8 x 19-1/4Number of T-slots.............................. 2 in table, 2 in base ........ 2 in table, 2 in base .....2 in table, 2 in baseSpindle Speed Range (RPM) ............60-450 & 240-1800 ...........60-450 & 120-900 ....... 60-450 & 120-900....................................................................................N/A .......120-900 & 240-1800 ... 120-900 & 240-1800Overall Height (in.) ........................................................73 ....................................73 ................................ 73Base Size (in.)...........................................19-3/8 x 29-1/4 ............... 19-3/8 x 29-1/4 ............19-3/8 x 29-1/4Table Travel (in.) .....................................................26-1/2 ............................. 26-1/2 ..........................26-1/2Net Weight – approximate (lbs.) .................................660 ..................................660 .............................. 660Shipping Weight – approximate (lbs.) .........................790 ..................................790 .............................. 790The above specifications were current at the time this manual was published, but because of our policy ofcontinuous improvement, WMH Tool Group reserves the right to change specifications at any time andwithout prior notice, without incurring obligations.