Jet JHG-600K Operation Manual

Contents

87.4 Stationary UseThis tool can also be used in stationary mode.• Place the tool onto the workbench.• Secure the cable to prevent pulling the tool off the workbench.• Carefully switch the tool on.Make sure that the nozzle always points away from you and any bystanders.Make sure not to drop anything into the nozzle.7.5 Cooling DownThe nozzle and accessory become very hot during use. Let them cool down before attempting to move or store the tool.• Switch the tool off and allow to cool for at least 30 minutes.• To reduce cooling time, set tool at lowest temperature and air settings and allow to run for a few minutes before switching off.8. Maintenance and CleaningAttention! Before performing any work on the equipment, disconnect the power plug.8.1 MaintenanceYour power tool has been designed to operate over a long period of time with a minimum of maintenance.Continuous satisfactory operation depends upon proper tool care and regular cleaning.8.2 LubricationYour power tool requires no additional lubrication.8.3 Cleaning• Keep the ventilation slots of the machine clean to prevent overheating of the motor.• Regularly clean the machine housing with a soft cloth, preferably after each use.• Keep the ventilation slots free from dust and dirt.• If the dirt does not come off use a soft cloth moistened with soapy water.Never use solvents such as gasoline, alcohol, ammonia, etc. These solvents may damage the plastic parts.

/ 9

Related manuals for Jet JHG-600K