8LubricationLubricate ball oilers (A, Fig. 4) found by the X/Y-axis hand wheels, the oiler found by theraising/lowering crank handle, and the oiler onthe front of the bed once daily with Mobil DTEOil Heavy Medium.Lubricate the ways (B, Fig. 4) once daily withMobil DTE Oil Heavy Medium.If the head does not raise, or lower smoothlyapply Mobilith AW2 to the rack, and MobilDTE Oil Heavy Medium to the column.If the feed handles do not turn smoothly applyMobilith AW2 to the cross, and longitudinal leadscrews (C, Fig. 4). Access the cross lead screwby moving the table forward and removing theway cover.The spindle bearings are permanently sealedand require no lubrication.Electrical Connections WARNINGA qualified electrician must make allelectrical connections!Failure to comply may cause serious injury!Before making any electrical connections, makesure the power source available is compatiblewith the machine. Also, press the “Off” buttonon the front of the machine before connecting tothe power source.The JMD-15 is rated at 115/230V and comesfrom the factory prewired at 115V. Thismill/drill comes with a plug designed for use ona circuit with an outlet that looks like (A, Fig. 5).The JMD-15 has a grounding prong asillustrated in (A, Fig. 5).To switch the JMD-15 to 230V operation:1. Disconnect the machine from the powersource.2. Remove the junction box cover on themotor.3. Change the wires according to the diagramon the inside of the junction box cover, andreplace the junction box cover.4. Change the plug to one that is rated 230V orhard wire the power cord.The JMD-18/18PFN is rated at 230V only.Again, be sure the power source is compatiblewith the mill/drill before connecting to the powersource. Make sure the mill/drill is properlygrounded.