Jet JMS-10X Operating Instructions And Parts Manual

Contents

Jet JMS-10X Operating Instructions And Parts Manual Manual pdf 13 page image

13Cord length Wire gauge (AWG)0 – 25 ft. 1625- 50 ft. 14Table 3Important: Make certain the receptacle in questionis properly grounded. If you are not sure, have aregistered electrician check the receptacle.8.0 AdjustmentsNote: Your miter saw was adjusted by themanufacturer. However, during shipment slightmisalignment may have occurred. Check thefollowing settings and adjust if necessary prior tousing this miter saw.8.1 Support footThe foot (A, Figure 8-1) can be turned in or out toadjust its height. It is designed to provided supportfor the miter table when locking handle is pusheddown or when cutting head is brought forward forslide-cutting. The foot should be adjusted to contactsurface of bench or worktable.8.2 Miter angle settingThe miter scale shows miter angles from 0° to 52°to the left, and 0° to 60° to the right.To set miter angle:1. Lift up on miter lock handle (B, Figure 8-1) tounlock table.2. Press and hold release button (C) and use miterlock handle to push cutting arm until desireddegree aligns with angle indicator (D).3. Push down miter lock handle (B) to lock theposition.Note: The release button (C) can be continuouslyengaged to bypass the stops. This is convenientwhen frequent and quick adjustment of miter anglesis needed.1. Push down release button (C) and push in pin(E). Release button is now continuouslyengaged.2. Grasp handle (B) and freely rotate cutting arm.3. Press release button (C) again to disengagepin.Figure 8-1: selecting miter angles8.2.1 Miter positive stop selectionThe miter saw table has preset stops for quick andaccurate positioning at common angle settings of 0°,15°, 22.5°, 31.6°, and 45° left and right; and 60°right.1. Lift up on miter lock handle (B, Figure 8-1) tounlock table.2. Press release button (C) and move table withhandle (B). As scale indicator approaches thedesired degree, release the button (C). Thetable will engage the next positive stop.3. Push down miter lock handle (B) to lock theposition.8.2.2 Miter scale indicator alignment1. Rotate table to the 0° stop.2. If indicator (D, Figure 8-1) does not align withzero on scale, loosen screw and adjust indicatorto 0° mark. Retighten screw.8.3 Table extensions and work stopPull up lock handle (H, Figure 8-2) and slide tableextension outward, as shown. Push down lockhandle to secure position.Raise workstop (J) for quick positioning of stockwhen cutting multiple pieces of equal length.Figure 8-2